andro的id 和linux的休眠唤醒机制.docVIP

android 和linux的休眠唤醒机制 四、android层源码解析hardware/libhardware_legacy/power/power.c //HAI层 2. frameworks/base/core/jni/android_os_Power.cpp //jni层frameworks/base/core/java/android/os/Power.java //java层 在linux之上经过android的软件堆层层封装,最终在上层的java应用程序中使用。休眠唤醒也是从最上层发出的命令，然后一层一层地将参数解析，往最底层传，最后走上标准linux的休眠唤醒之路。 这一部分将会初略分析休眠唤醒机制上linux之上所走的路线。 在linux之上，存在一个hal层，专门做和linux内核设备打交道的事情，这里也不例外。休眠唤醒机制的hal层源码位于：@hardware/libhardware_legacy/power/power.c 该文件源码比较简单，下面列举重点片段： enum { ACQUIRE_PARTIAL_WAKE_LOCK = 0, RELEASE_WAKE_LOCK, REQUEST_STATE, OUR_FD_COUNT }; const char * const NEW_PATHS[] = { /sys/power/wake_lock, /sys/power/wake_unlock, /sys/power/state }; static int g_initialized = 0; static int g_fds[OUR_FD_COUNT]; static const char *off_state = mem; static const char *on_state = on; static int open_file_descriptors(const char * const paths[]) { int i; for (i=0; iOUR_FD_COUNT; i++) { int fd = open(paths[i], O_RDWR); if (fd 0) { fprintf(stderr, fatal error opening \%s\\n, paths[i]); g_error = errno; return -1; } g_fds[i] = fd; } g_error = 0; return 0; } static inline void initialize_fds(void) { if (g_initialized == 0) { if(open_file_descriptors(NEW_PATHS) 0) { open_file_descriptors(OLD_PATHS); on_state = wake; off_state = standby; } g_initialized = 1; } } int acquire_wake_lock(int lock, const char* id) { initialize_fds(); if (g_error) return g_error; int fd; if (lock == PARTIAL_WAKE_LOCK) { // 上层传下来的lock type fd = g_fds[ACQUIRE_PARTIAL_WAKE_LOCK]; } else { return EINVAL; } return write(fd, id, strlen(id)); } int release_wake_lock(const char* id) { initialize_fds(); // LOGI(release_wake_lock id=%s\n, id); if (g_error) return g_error; ssize_t len = write(g_fds[RELEASE_WAKE_LOCK], id, strlen(id)); return len = 0; } int set_screen_state(int on) { QEMU_FALLBACK(set_screen_state(on)); LOGI(*** set_screen_state %d, on); initialize_fds(); if (g_error) return g_error; char buf[32]; int len; if(on) len = sprintf(buf, on_state); else len = sprintf(buf, off_state); len = write(g_fds[REQUE