PPAP_D的isposition_Guideline_041305.pptVIP

PPAP Disposition Guidelines: Examples of Distinguishing Bad or Incomplete PPAPs 04/13/05 Guideline Items 1. Example of Missing DIM on FAI 2. Example of Incorrect TOL on FAI 3. Confirm Cp ≥ 2.0 and Cpk ≥ 1.5 4. Confirm the inspection method used to gather GRR data matches the method/s used to obtain both FAI and Cp/Cpk measurements 4. (cont’d) Confirm that GRR “% tolerance” value is less than 20% 5. Example of missing drawing notes and statement of conformance in FAI 6. Disposition all “Alert” and “Reject” FAI measurements 7. Confirm that there are at least 3 sample measurements for each DIM on the FAI 8. Be Cautious of Supplier Changing/Deleting PPAP template formulas 9. Confirm that the correct drawing revision is attached in the PPAP 10. Confirm that the supplier does not use identical FAI measurements from cavity to cavity for multi-cavity tools. Explanation of PPAP data Items: Confirm all dimensions called out on the drawing are measured on the FAI. Confirm nominal dimensions and tolerances on the FAI sheet are the same as on the drawing. Confirm minimum process capability requirements: Cp ≥ 2.0 and Cpk ≥ 1.5. Confirm the inspection method used to gather GRR data matches the method(s) used to obtain both FAI and Cp/Cpk measurements. Confirm the GRR “% tolerance” value is less than 20%. Confirm that all notes called out on the drawing are placed on the FAI sheet and the supplier dispositions are present (i.e. conforms or does not conform). Disposition all FAI measurements that appear as “Alert” and “Reject” Confirm that there are at least 3 sample measurements for each dimension on the FAI. Be cautious of the supplier changing or deleting formulas in the template to make it appear that parts are within spec. Confirm that the correct drawing revision is attached in the PPAP. Confirm that the supplier does not use identical FAI measurements from cavity to cavity in multi-cavity tools. DIM 7.00 is called out on the drawing but it is not measured on the FAI. Re