[最终程序.docVIP

#include REG52.H #include intrins.h #define uint unsigned int #define uchar unsigned char sbit DS1302_CLK = P3^7; //实时时钟时钟线引脚 sbit DS1302_IO = P3^6; //实时时钟数据线引脚 sbit DS1302_RST = P3^5; //实时时钟复位线引脚 sbit wireless_1 = P3^0; sbit wireless_2 = P3^1; sbit wireless_3 = P3^2; sbit wireless_4 = P3^3; sbit Beep_flag = P2^4; sbit led_flag = P2^4; sbit ACC0 = ACC^0; sbit ACC7 = ACC^7; char hide_sec,hide_min,hide_hour,hide_day,hide_week,hide_month,hide_year; //秒,分,时到日,月,年位闪的计数 sbit Set = P1^4; //模式切换键 sbit Up = P1^6; //加法按钮 sbit Down = P1^7; //减法按钮 sbit out = P1^5; //立刻跳出调整模式按钮 sbit DQ = P2^3; //温度传送数据IO口 char done,count,temp,flag,up_flag,down_flag; uchar temp_value; //温度值 uchar TempBuffer[5],week_value[2]; void show_time(); //液晶显示程序 /***********1602液晶显示部分子程序****************/ //Port Definitions********************************************************** sbit LcdRs = P2^5; sbit LcdRw = P2^6; sbit LcdEn = P2^7; sfr DBPort = 0x80; //P0=0x80,P1=0x90,P2=0xA0,P3=0xB0.数据端口 //内部等待函数************************************************************************** unsigned char LCD_Wait(void) { LcdRs=0; LcdRw=1; _nop_(); LcdEn=1; _nop_(); LcdEn=0; return DBPort; } //向LCD写入命令或数据************************************************************ #define LCD_COMMAND 0 // Command #define LCD_DATA 1 // Data #define LCD_CLEAR_SCREEN 0x01 // 清屏 #define LCD_HOMING 0x02 // 光标返回原点 void LCD_Write(bit style, unsigned char input) { LcdEn=0; LcdRs=style; LcdRw=0; _nop_(); DBPort=input; _nop_();//注意顺序 LcdEn=1; _nop_();//注意顺序 LcdEn=0; _nop_(); LCD_Wait(); } //设置显示模式************************************************************ #define LCD_SHOW 0x04 //显示开 #define LCD_HIDE 0x00 //显示关 #define LCD_CURSOR 0x02 //显示光标 #define LCD_NO_CURSOR 0x00 //无光标 #define LCD_FLASH 0x01 //光标闪动 #define LCD_NO_FLASH 0x00 //光标不闪动 void LCD_SetDi