厂区测量控制网施测方案..doc

苏丹AL-Fula 3×135MW电力项目 Sudan AL-Fula 3×135MW electric power project 厂区测量控制网 施测方案 Survey plan of measurement control net in the plant area 批准：Approval 复核：recheck 测量：measure 中国十七冶苏丹富拉电厂 工程项目经理部 Management department of MCC17 of the project of AL-Fula power plant in Sudan 二O一0年十二月七日 December 7th 2010 厂区测量控制网施测说明 Power project plant description 一．工程概况General condition of project 根据厂区实际情况，厂区控制点布设成矩形方格网，共十四个点 According to the actual situation of the plant area, the control points in the plant area location is rectangle grid net, and the quantity of the points is totally 14. 二．施测依据Basis for measurement 根据电子版厂区总平面图及甲方提供的E01-E14测量控制点 The electronic edition overall site plan of the plan area and the E01-E14 measurement control points offered by the first party. 三．使用仪器及执行标准Instrument and implement standards 测角，测距采用日本尼康DTM-352型全站仪标称精度为±（2+2ppm×D）仪器编号为014710，高程测量采用中国苏州一光DSZ2+FS1精密自动安平水准仪，编号为234479，每公里往返测量高差标准偏差≦±0.5mm，执行标准《GB50026-2007》工程测量规范。 The measuring angle and measuring distance use the Japanese Nikon OTM-352 type total station, and the marker precision is （2+2ppm×D）,and the instrument serial number is 014710. The height measurement uses the Chinese Suzhou Yiguang DSZ2+FS1 precise automatic level, and the serial number is 234479, and the height difference standard deviation of the round trip measurement per kilometer is ≦±0.5mm. The implement standard is《GB50026-2007》project measurement standard. 四．控制点埋设及标注Burying and marking of the control points 控制点初定开挖土方后，现场支模浇筑砼，墩顶埋设铁件及螺栓，坐标以铁件上冲的“⊙”为准，水准点以铁件边“T”螺栓顶为准。(见附图3)。 After the control points initialization earth excavation, field formwork pour concrete, and bury iron castings and bolts in the pier top. The coordinate subject to “⊙”stamped in the iron castings, and the benchmarks subject to the “T”top of the bolts beside the iron casting.（see fig.3） 五．技术要求Technical requirments 按Ⅰ级导线精度布网，采用轴线法，测角中误差为5″，边长相对中误差1/30000，直线度的限差为180o±5″以内，交角限差为90o±5″，高程按三等水准要求，环线闭合差为12√L