舰船建模过程(中英文对照)..docVIP

舰船建模技术 技术, structure, generated, computer, currently（一般的） 舰船建模技术Below are some pictures of my making of French early ships. Im currently working on :- Battleship Hoche（恒河号战列舰）- Battleship Bouvet（贝尔特号战列舰）- Armored cruiser Pothuau(Pothuau 号装甲巡洋舰)- Armored cruise Jeanne dArc（Jeanne dArc号装甲巡洋舰）(each ship at both 1:700 and 1:350 scale)【每个舰船模型的比例是1:700或1:350】I started from the official Navy plans. I put the files in my computer and extracted the hull frames and longitudinal sections. Heres an example with Hoche :【我首先将搜集的海军官方资料输入电脑，然后电脑显示出出船体横向与纵向的结构面。这里是恒河号战列舰的例子】 then I computer generated the whole hull structure at both scales (again the Hoche) :【我计算出船体的整体结构（以恒河号为例）】 下载 (119.87 KB)舰船建模技术 1?小时前 child 发短消息 加为好友 child 当前在线 UID 43662? 帖子 275? 精华 0? 积分 704? 威望 283 ? 金钱 0 ? 在线时间 4 小时? 注册时间 2012-3-19? 最后登录 2012-4-15? I photo etched my project to get a full set of frames and bow + stern structures (Heres Bouvet @ 1:700) :【我通过图像详细显示出Bouvet号（1:700）的整体框架和它船首、船尾的结构】 下载 (65.5 KB)舰船建模技术 半小时前 I assembled both hull parts (I planned a waterline option, hence the two parts). Heres Hoche again : 下载 (28.57 KB)舰船建模技术 半小时前 Then came the filling stage. I used sawn blocks of prototypying board, which is a silica bonded polyurethane resin board used in the industry to make prototypes for casting. This excellent product is worked like balsa wood, but remain stable and watertight for wet sanding. Blocks roughly traced using the brass frames as templates, then roughly cut with an electromagnetic vibrating wire saw and glued in place with Zap-a-Gap, with brass photo etched frames inserted.（然后就是组装阶段。 我用成型砖的“原型板”,这是一种工业上用于原型铸造的石英聚氨酯树脂板。 这种优秀的产品象轻木,但有良好的稳定性和水密性。 各部分描绘在黄铜板上，作为模板,用胶水粘在一个合适位置，比照着图纸，然后用振动线锯粗略剪切.）【翻译的不好，请参看下图理解】The sanding step was very easy : one had just to sand the block until the paper touches the brass frames which are harder, making a different noise on them. This rumble noise was the signal to stop. Using this simple way I managed to shape the hulls quick