GF报警研究报告.docVIP

Description of alarms—报警内容说明 Code 代码 Message 故障信息 Remarks 备注 Activities 措施 E001 Tip warning channel A 路径A台阶报警 Stepper A in prewarning (see section 5.6.3.4)台阶递增A预报警（看章节5.6.3.4） The red led W.STEP. A on the front panel is on. 控制器正面焊接台阶递增B红灯亮 Indication that tip change or dress on channel A must be done soon表明路径A马上要修磨或更换电极帽 E002 Tip warning channel B 路径B台阶报警 Stepper B in prewarning (see section 5.6.3.4).台阶递增B预报警（看章节5.6.3.4） The red LED W.STEP. B on front panel is on. 焊接台阶递增B红灯亮 Indication that tip change or dress on channel B must be done soon 表明路径B马上要修磨或更换电极帽 E003 Warning threshold cable channel A：路径A电缆极限报警 Cable wear counter A in prewarning. (see section 3.4.1.2) 路径A电缆磨损预报警 Indication that maintenance for the cable on channel A must be done soon表明路径A电缆马上需要维修 E004 Warning threshold cable channel B：路径B电缆极限报警 Cable wear counter B in prewarning. (see section 3.4.1.2) 路径B电缆磨损预报警 Indication that maintenance for the cable on channel B must be done soon表明路径B电缆马上需要维修 E005 Meas.curr.( min threshold 电流检测值小于最小极限 The measured current value was n-times between %I.min and %I.lim ( n = programmed numbers of weld alarm threshold )焊接时，电流检测值在最小值和电流极限之间 The red LED LOW CURR on frontpanel is on.控制器正面的‘电流过低’红灯亮 Possible reasons :可能原因 Tips do not close 端面没有闭合 Tips are damaged端面受损 Voltage drop in power line能量功率线路电压下降 Current sensor damaged电流传感器受损 Squeeze time too short焊接顺序时间过短 Programmed current (max.编程电流大于最大值 Cables or band damaged.电缆受损 Check value of tolerance (see section 4.4.7.19)检查公差值（看章节4.4.7.19） Increase weld alarm threshold. (see section 3.1.1.5)增加焊接报警极限 Check tip force检查电极端面压力 Check surface of tips检查电极端面表面状态 Check line voltage 检查线路电压 Check current sensor ( cabling and positioning )检查电流传感器（电缆线路和位置） Check squeeze检查焊接顺序 Check cables and secondary loop 检查电缆和次级回路 E006 Meas.curr.( max. threshold 电流检测值大于最大极限 Monitored current .( %I.max Possible reasons:监测的电流大于最大电流值，可能原因 Fault in WELD 334。焊接控制器故障 Weld transformer faulty焊接变压器故障 Check value of max tolerance (see section 4.4.7.18)检查最大公