zigbee网络设备启动.docVIP

Zigbee网络设备启动—主要函数说明 2010-07-09 20:32:17| 分类： HYPERLINK /blog/#m=0t=1c=fks_087068080094087066092095085095087083080069092086086066Zigbee|字号 订阅 使用的协议栈版本信息: ZigBee2006\ZStack-1.4.3-1.2.1 1、ZDApp_Init()及其中几个函数的说明.(1)ZDApp_Init()****************************************void ZDApp_Init( byte task_id ){ uint8 capabilities; // Save the task ID ZDAppTaskID = task_id; // Initialize the ZDO global device short address storage ZDAppNwkAddr.addrMode = Addr16Bit; ZDAppNwkAddr.addr.shortAddr = INVALID_NODE_ADDR; //0xFFFE (void)NLME_GetExtAddr(); // Load the saveExtAddr pointer. // Check for manualHold Auto Start //检测到有手动设置SW_1则会设置devState = DEV_HOLD,从而避开网络初始化 ZDAppCheckForHoldKey(); // Initialize ZDO items and setup the device - type of device to create. ZDO_Init(); //通过预编译来初始化一些功能函数.  // Register the endpoint description with the AF // This task doesnt have a Simple description, but we still need // to register the endpoint. afRegister( (endPointDesc_t *)ZDApp_epDesc ); #if defined( ZDO_USERDESC_RESPONSE ) ZDApp_InitUserDesc();#endif // ZDO_USERDESC_RESPONSE // set broadcast address mask to support broadcast filtering NLME_GetRequest(nwkCapabilityInfo, 0, capabilities); NLME_SetBroadcastFilter( capabilities ); // Start the device? if ( devState != DEV_HOLD ) { ZDOInitDevice( 0 ); } /*如果devState=DEV_HOLD,则不会调用ZDOInitDevice()来初始化网络 不组网也不进网.LED4闪烁指示这是一个非自动启动模式,等待应 用程序来开启是网络设备*/ else { // Blink LED to indicate HOLD_START HalLedBlink ( HAL_LED_4, 0, 50, 500 ); } ZDApp_RegisterCBs();}****************************************这里说明三个函数:ZDAppCheckForHoldKey()ZDO_Init()ZDOInitDevice( 0 ) (1)ZDAppCheckForHoldKey()**************************void ZDAppCheckForHoldKey( void ){#if (defined HAL_KEY) (HAL_KEY == TRUE) //个人认为：可以直接通过读取按键来看是否需要采用HOLD_START模式 //如果发现SW_1按下(普通按键吧)/向上(Joystick up),则设置DEV_HOLD; // Get Keypad directly to see if a HOLD_START is needed. // Hold down the SW_BYPASS_START key (see