Equipment Safety Standard-HazardousSubstances-20150526.pptVIP

*  PSM-Ammonia 急停 在机房外至少装有1个紧急停机装置可以停止机房内的所有设备的运行: 如果技术上不能做到，则有明确的程序控制来达到安全快速地关闭车间内的所有的设备。 集中防护措施 在车间附近装有洗眼装置（处于正常可用状态） 在车间附近装有紧急喷淋装置（处于正常可用状态） *  PSM-Ammonia Emergency shut down Is at least 1 emergency shut down installed outside the machinery room? Collective Protective Equipment Is an eyewash station installed (and in good working order) near the machinery room? Is an emergency shower installed (and in good working order) near the machinery room? *  PSM-Ammonia 2.3 氨检测仪 制冷车间安装有氨泄漏报警仪？ 如果用氨直冷，氨泄漏检测仪需安装在氨可能泄漏的区域（酿造车间的热交换器、发酵罐等等）。 （新）检测仪必须具有3级报警的报警器： *  PSM-Ammonia 2.3. Ammonia Detection Is the machinery room equipped with NH3 detection system? In case of direct cooling, is NH3 detection installed in any area where a leakage of NH3 is possible (heat exchangers in Brewing, Fermentation vessels,.....)? Is the NH3 detection system operated, calibrated and maintained according to the manufacturers instructions by trained workers? Has the (new) NH3 detection system 3 alarm levels (see annex 2 of VPO.SAFE.3.1.08. Hazardous Substances)? *  PSM-Ammonia 管道和设备的防护 所有管道和设备都按照管道的设计要求进行正确地支撑和固定: 根据管道的直径，来确定对于水平管道进行支撑的指导准则 100mm:每3米 100-400mm:每5米 400mm:每7米 （100mm=4英寸/1米=3.3英尺） 正确地保护管道和设备避免被车辆、震动、热膨胀、当地天气状况和地震因素等的损坏（叉车、货车等） *  PSM-Ammonia Protection of piping and equipment Is all piping and equipment supported and anchored as required by piping design requirements? Are piping and equipment properly protected against damage by vehicles (fork lift trucks, trucks,...), vibrations, thermal expansion, local weather conditions and seismological activity? *  PSM-Ammonia 供水 车间附件有足够的消防栓，确保在大的氨泄漏时产生水幕 氨清除器/吸收器 通风设施的出口是否安装了氨吸收器/清除器？ 车间的通风出口处和安全阀的出口应安装氨吸收器/清除器，应考虑 o 当地的法规 o 设施选址 o PHA/风险分析 对于在居民区附近的新的氨设施，必须安装氨吸收器/清除器 *  PSM-Ammonia Water Supply Are sufficient fire hydrants present in the vicinity of the machinery room to allow a water curtain in case of major ammonia spills? Ammonia Scrubbers/Absorbers Is the outlet of the ventilation connected to an ammonia scrubber/absorber? *