自攻类紧固件的应用和安装扭矩的设定探讨-讲稿.ppt

More than 90% of all plastics are of the thermoplastic variety. Once a thermoset material hardens it will not melt again. Thermosets are used for some electrical components. Thermosets are usually used in areas where they will be subjected to high heat, or where high stiffness is required. The filler content of thermoset materials can be much higher than thermoplastics (up to 80% for aerospace parts). Thermoplastics are usually injected molded. Most general purpose plastics melt at 400-500 degrees. If a thermoplastic has a large amount of filler, it may become stiff enough it requ