通用压缩率45页uscar21.docVIP

PERFORMANCE SPECIFICATION FOR CABLE-TO-TERMINAL ELECTRICAL CRIMP 端子压接的性能规范 1. SCOPE范围 IMPORTANT NOTICE: In any intended vehicle application, if the products covered by this specification are, or may be, subjected to conditions beyond those described in this document, They must pass special tests simulating the actual conditions to be encountered before they can be considered acceptable for actual vehicle application. Products certified by their supplier as having passed specific applicable portions of this specification are not to be used in applications where conditions may exceed those for which the product has been satisfactorily tested.The Authorized Person is the final authority as to what tests are to be performed on his or her parts and for what purpose these tests are required. He or she is also the final authority for resolving any questions related to testing to this specification and to authorizing any deviations to the equipment or procedures contained in this specification. Any such deviation must be documented and included in the final test report. 重要提示：在任何汽车应用中，对于本规范没有涉及到的情况，产品必须通过相应的特殊试验，该试验的试验条件应该模仿汽车在实际使用中的条件。对于通过了该规范中要求的试验的产品，使用时也不能应用于超过该试验条件的场合。权威人士是最终有权指出他或她的产品需要做哪些试验并且这些试验有哪些目的的人。对于解决该规范中出现的任何试验问题，对于与该规范中包含的试验设备和试验程序相违背的情况，他或她仍然是有最终决定权的人。试验中出现的任何不符合性都必须作记录，并记录在最终试验报告中。 1. This specification defines basic test methods and requirements for solder-less crimped connections. 1.在该规范中定义了关于纯压接连接（没有焊接）的基本试验方法和试验要求。 2. Crimp applications validated to this specification supercede any crimp information on Ford, GM, or DaimlerChrysler component prints. It is preferred that the terminal supplier do testing and selection of crimp tooling and supply detailed crimp information or make crimp tooling available to the wiring assembly supplier actually doing the production crimping. If the wiring supplier deviates from this information or it is not available, then the responsibility for testing to this specification or getting approval from the customer with appr