英飞凌通信协议.docVIP

英飞凌通信协议 总共有以下控制命令输出: - Service Mode - press any key to start e = erase corr fac //擦除标定数据 s = single scan //单次扫描 b = bottom 1x pulse //单次低端平衡脉冲 t = top 1x pulse //单次顶端平衡脉冲 i = inter block 1x pulse //单次block之间平衡脉冲 m = scan+balancing2 (manu mode) u = scan+balancing1 (auto mode) v = scan+balancing2 (auto mode) y = scan+InterBlockBalancing (auto mode) c = calibration by hand a = calibration by file Format: chn_0, chn_1, ...., chn_11, Block, a d = test of Secs, PrimL and PrimH Mosfets k = change COM speed to 19,200k l = change COM speed to 115,20k 更详细资料请参考： BatteryManagementSoftware_22.pdf 39页 通电后的BMS反馈信息: ******************************************* -BATTERY MANAGEMENT May 25 2010 14:30:20- -uC SW for Litec BMS (12 cells), BOARDv4.0- -COM speed: 19,2kBaud- -CAN speed: 250 kBaud- ******************************************* Read Flash Cal. Fac.: cal.fac. chn.0: 1.1294 cal.fac. chn.1: 1.1167 cal.fac. chn.2: 1.1135 cal.fac. chn.3: 1.1257 cal.fac. chn.4: 1.  ******************************************* -BATTERY MANAGEMENT May 25 2010 14:30:20- -uC SW for Litec BMS (12 cells), BOARDv4.0- -COM speed: 19,2kBaud- -CAN speed: 250 kBaud- ******************************************* Read Flash Cal. Fac.: cal.fac. chn.0: 1.1294 cal.fac. chn.1: 1.1167 cal.fac. chn.2: 1.1135 cal.fac. chn.3: 1.1257 cal.fac. chn.4: 1.1311 cal.fac. chn.5: 1.1176 cal.fac. chn.6: 1.1207 cal.fac. chn.7: 1.1207 cal.fac. chn.8: 1.1186 cal.fac. chn.9: 1.1216 cal.fac. chn.10: 1.1307 cal.fac. chn.11: 1.1473 cal.fac. block: 1.0840 STATE - Reset S0 Warning: T1 Open Error: UblockUnderLevel Slave: Service mode - Service Mode - press any key to start e = erase corr fac s = single scan b = bottom 1x pulse t = top 1x pulse i = inter block 1x pulse m = scan+balancing2 (manu mode) u = scan+balancing1 (auto mode) v = scan+balancing2 (auto mode) y = scan+InterBlockBalancing (auto mode) c = calibration by hand a = calibration by file Form