屋面RA-MPRoofingforBahamarProject资料.pptVIP

9. RA-MP 屋面施工前试验 静载风压试验 Structural Performance: Provide concrete roof tile assemblies capable of withstanding the effects of gravity loads and the following loads and stresses within limits and under conditions indicated, based on testing according to ASTM E 1592 9. RA-MP 屋面施工前试验 静载风压试验 Structural Performance: Provide concrete roof tile assemblies capable of withstanding the effects of gravity loads and the following loads and stresses within limits and under conditions indicated, based on testing according to ASTM E 1592 9. RA-MP 屋面施工前试验 静载风压试验 Structural Performance: Provide concrete roof tile assemblies capable of withstanding the effects of gravity loads and the following loads and stresses within limits and under conditions indicated, based on testing according to ASTM E 1592 The test specimens shall be of sufficient size At each increment of load, maintain pressure for not less than 60 s and until the dial gages indicate no further increase in deflection. Proceed as above with successive increments that do not exceed one sixth the maximum specified test load until failure or the specified ultimate load is reached. Unless otherwise specified, the first increment of load shall be nominally equal to one third the anticipated ultimate load. 9. RA-MP 屋面施工前试验 Testing for resistant of specified uplift pressures 动荷载情况下试验 SECTION 01 4339 - ENCLOSURE PERFORMANCE AND LABORATORY MOCKUPS E. Performance Requirements for Roofing Systems: 1. Roofing systems shall resist uplift pressures indicated for Design Wind Loads as determined through preconstruction testing specific for this project as follows. a. “Testing Application Standard (TAS) 114-95 Appendix C Test Procedure For Simulated Uplift Pressure Resistance Of Roof System Assemblies.” b. “Testing Application Standard (TAS) 114-95 Appendix B, Test Procedure For Simulated Dynamic Uplift Pressure Resistance of Mechanically Attached Roof System Assemblies.” c. “Testing Application Standard (TAS) 114-95 Appendix J, Test Pr