毕业设计-某矿选矿设计说明书.doc

毕业设计 某矿选矿设计说明书  摘 要 按照毕业设计任务书的要求，进行了***铅锌矿优先浮选1750吨/日选矿厂设计，产品为铅精矿和锌精矿。 在****的***铅锌矿进行了为期三周毕业实习，收集相关设计资料的基础上。确定了各车间的工作制度，对设计工艺流程进行了选择和论证，确定了设计的工艺流程，即：破碎采用三段半开路流程，磨矿采用一段闭路流程，浮选采用优先浮工艺，精矿采用先浓缩后过滤的两段脱水。 对设计工艺流程进行了工艺指标计算，包括破碎、筛分、磨矿、浮选（包括矿浆流程）和脱水流程。对破碎、筛分、磨矿、分级、浮选及脱水设备进行了选择计算和方案比较，确定了工艺所需的工艺设备。 进行了厂房总体布置，并进行了厂房内的设备配置。根据选厂房的地形条件，沿山坡地布置，其中，粗碎、中细碎、筛分厂房分开布置，粗碎、中细碎及筛分车间平行等高线配置。磨矿浮选共厂房配置，其中磨矿采用纵向配置，浮选机采用横向配置。浓缩机配置在露天，过滤机与精矿仓配置在厂房内。完成 了粗碎、中细碎、筛分、磨浮、脱水车间平断面图、数质量及矿浆流程图和设备联系图共10张。 关键词：选矿厂设计 铅锌矿 浮选 *** Abstract According to the request of the intruction of plant design for undergraduated, the design of Huangshaping Pb -Zn Mine concentrator with the capacity of 1750t/d, and the products are lead and zinc concentrate. On the basis of practice in Huangshaping Pb -Zn Mine for three weeks, and the collection of data, The work institutions of each workshop were determined, and the technological process was also chosed and reasoned The process of crushing is three sections with half open circuit, the grinding process is one section with closed circuit, the floation process is selective flotation of lead minerals, and a process with two sections dewatering circiut which included concentration and filtion was adopted . Technological parameters of crushing,screening, grinding ,floation(include the circuit of pulp)and dewatering were computed, respectively. Then the technological parameters of equipments were computed and the schemes of equipments were compared and the optimal equipments were determined. The general arrangement of concentrator plant and the allocation of equipments in diferent workshop were presented. According to the topography of plant site, plants were arranged along the slope of mountain. The workshops of coarse crushing, middle and fine crushing and screening were aloted independent. Arrangment with parallel contour line of coarse crushing workshop、 middle and fine crushing and screening workshops were used. The workshops of