用PWM_ON_PWM模式抑制无刷直流电机换相引起的脉动转矩毕业论文外文文献翻译及原文.doc

毕 业 设 计（论文） 外 文 文 献 翻 译 文献、资料中文题目：用PWM_ON_PWM模式抑制无刷直流电机换相引起的脉动转矩 文献、资料英文题目： 文献、资料来源： 文献、资料发表（出版）日期： 院 （部）： 专 业： 班 级： 姓 名： 学 号： 指导教师： 翻译日期： 2017.02.14 外文资料原文 Commutation Torque Ripple Reduction in BLDC Motor Using PWM_ON_PWM Mode Guangwei Meng, Hao Xiong, Huaishu Li Department of Electrical Engineering, Naval University of Engineering, Wuhan, China. Abstract--The paper analyzes the steady commutation process of the BLDC motor using PWM mode, confirms the commutation time to keep noncommutation phase current amplitude constant during commutation period by way of PWM in the period to implement the compensation control to eliminate commutation torque ripple under both low speed and high speed operation, investigates the effect by PWM mode on a three-phase six-state 120° turn-on BLDC motor, and presents torque ripple compensation control in PWM_ON_PWM mode, which can not only entirelyeliminate torque ripple resulted from the current emerging in the turn-off phase during non-commutation period but also compensate torque ripple caused by the commutation current during commutation period. Index Terms—BLDC motor, commutation, PWM, torque ripple. I. INTRODUCTION The BLDC motors have been widely used due to its features － a simple structure, good speed adjusting performance,high powerdensity, low noise and simple control, etc. It is a hotspot to suppress the torque ripple and improve the control performance of a BLDC motor with the trapezoidal back emf. BLDC motors usually operate in all kinds of PWM modes, which not only affect the dynamic loss of power switches and radiation uniformity, but also influence the torque ripple. It is an effective way to suppress the torque ripple through changing dc bus chopper control to remain non-commutation phase current amplitude constant, but it results into a more complex topology [1]-[3]. It is just fit for low speed applications to control non-commutation phase cur