T68镗床的控制系统的改造设计【毕业论文+CAD图纸全套】.doc

摘 要 中国是一个制造大国，制造业的发展对我们国家经济发建设发展的起着至关重要的作用。而随着社会的进步，科学技术的不断发展，机械业发生翻天覆地的变化 由于镗床运动形式多且复杂，精度要求高，传统的继电器控制系统接线复杂、可靠性差，不仅故障率高，且故障诊断和排除困难。针对这些缺点，提出基于可编程控制器控制技术，对T68型卧式镗床控制系统进行改造。 采用三菱FX2N系列可编程控制器完成对其控制系统改造。首先对T68镗床控制系统电气原理进行设计与分析，选取合适的可编程控制器机型，分配输入/输出地址，并绘制其接线图；然后，编制控制梯形图并分析；最后，对改造后的控制系统进行仿真。 通过可编程控制器的改造，T68镗床的可靠性和效率大大提高，故障率降低，诊断与维修都大为方便,对它控制系统的改造有着技术与经济的双重意义。。 关键词：可编程控制器，T68镗床，控制系统改造  ABSTRACT Our country is the biggest manufacturer of the world. The development of the manufacturing industry in the construction of our country economy plays a vital role. And along with the progress of the society, the development of science and technology, mechanical manufacturing also has taken place earth-shaking changes. Especially in machine tool equipment innovation, all kinds of hi-tech new products are introduced continuously. Especially, programmable controller is widely used in automatic control. More in control of the machine shows its unique advantages. Because the boring machine’s movement situation are varied and complicated. The traditional relay control system wiring complex, poor reliability and failure rate high, fault diagnosis and exclude difficulties. According to these shortcomings, Based on PLC control technology, transforming T68 type horizontal boring’s control system. Adopt Mitsubishi FX2N series programmable controller to transform the control system. Firstly, design and analysis its electrical principle. Select a suitable programmable controller models. Distribute I/O address, and draw the wiring diagram. Then, formulate control ladder diagram and analysis. Finally, the reformed control system was simulated. Through the PLC transformation, T68 boring reliability and efficiency are greatly improved. Failure rate are reduced. Diagnosis and maintenance are quite convenient. The transformation of its control system has technology and economic double meaning. Key words：PLC,T68 boring, Control system’s transformation  目 录 中文摘要 ABSTR