塑料把手塑料成型工艺与模具设计【毕业论文+CAD图纸全套】.doc

塑料把把手成型工艺与模具设计 摘要：本设计题目为塑料把手注射模设计，体现了把手类塑料零件的设计要求、内容及方向，有一定的设计意义。通过对该零件模具的设计，进一步加强了设计者注塑模设计的基础知识，为设计更复杂的注塑模具做好了铺垫和吸取了更深刻的经验。 本设计通过对贮油杯盖结构工艺的正确分析，设计了一副一模两腔的塑料模具。详细地叙述了模具成型零件包括定模板、动模板、型芯等的设计与加工工艺过程，重要零件的工艺参数的选择与计算，推出机构与浇注系统以及其它结构的设计过程，并对试模与产品缺陷作了介绍。 本设计在型芯固定板上应用了Z形拉料杆，开模时通过Z形拉料杆将浇注系统凝料从定模中拉出，然后通过推板脱模机构将塑件和浇注系统凝料从动模一侧脱下。这种机构脱模可靠，设计方便，且在模具中占用空间较小，非常适合在本副模具中使用。 关键词：注射模 浇口 推板 Z形拉料杆 Plastic forming process to handle and die design Abstract：The design the topic for the emboby injection mold design of the handle, the handle reflects the type of plastic parts design, content and direction of the design of a certain significance. Through the design of the die parts to further enhance the design of injection mold designers the basic knowledge for the design of more complex injection molds and do a good job of paving the way to draw a more profound experience.  The design of oil storage lid on the process of the correct structural analysis, design of a four-cavity mold of a plastic mold. Detail molding die parts including the templates, dynamic templates, such as the design of core processes and processing, it is important parts of the process parameters of selection and terms, the introduction agencies and casting systems, as well as other structures of the design process, and test mode and product defects are introduced.  The fixed-core design in the application of the Z-shaped plate pull rod material, the mold through the Z-shaped pull rod will be expected condensate gating system in the material pulled out from the set mode, and then push the release plate and plastic parts will be gating system condensate is expected to take off the side of the driven mode. Such institutions Demoulding reliable, convenient design, and space in the mold of smaller, very suitable for the use of the die deputy. Key words: Injection Mold gate Z-shaped pull rod 1 绪 论 模具作为重要的生产装备和工艺发展方向，在现代工业的规模生产中日益发挥着重大作用。通过模具进行产品生产具有优质、高效、节能、节材、成本低等显著特点，因而在机械、电子、轻工、家电、通信