组装前请认真阅读说明书-Hobbyking.doc

组装前请认真阅读说明书 Before use, please read the explanations carefully! DRAGONFLY-1 EPP Instruction Manual说明书 Fuselage机身1 Wing主翼 2 Aileron 副翼 2 Elevator升降舵 1 Rudder方向舵 1 Landing Gear Strut起落架钢丝 2 Plywood Landing Gear Mount木质起落架座 1 Control Horn 舵角 4 Heat-shrink Tubing热缩管 1 Wheel 机轮 2 Plywood Motor Mount木质马达座 1 Plywood Pushrod Support连杆木支撑 2 Rear Furrow Wheel PVC Board Support尾轮支撑PVC板 1 Hinge 铰链 3 Carbon Fiber Rod 6*4*430mm碳纤管 2 Carbon Fiber Rod 3*2*65mm碳纤管 2 Carbon Fiber Rod 1.2*500mm碳纤管 2 Carbon Fiber Strip 5*430mm碳纤片 5 Elastic橡皮筋 4 Vertical Stabilizer Fastener垂直尾翼固定块 1 Steel Wire Z字形钢丝 4 1mm Connecting Rod 连杆钢丝 2 Pushrod Clip连杆卡子 2 Steel Wire L形钢丝 1 Cut 2 carbon fiber strips(160mm) and sharpen them. Glue the left and right wings and insert the 430mm strips to the slots. Put the 2 sharpened carbon fiber strips to the slots in the middle of the wings. 剪2根160mm长碳纤片，用刀把两端削尖。用胶水把左右机翼粘合，将430mm碳纤片插入机翼的缝隙里。将2根削尖的碳纤片插入机翼中段的缝隙。 Use quick-setting glue to fix the carbon fiber strips. Insert the 6mm carbon fiber rods to the slots of vertical stabilizer fasteners, glue them. Cut 3 suitable carbon fiber strips and glue them onto the front and trailing edge. 涂抹快干胶把碳纤片粘合牢固。将6mm碳纤管插入垂直尾翼固定块的槽里，用胶水固定。剪3根合适长度的碳纤片，用胶水将它粘合到机翼的前缘和后部。 Insert one end of the steel wire L to the vertical stabilizer. Use glue on the midline of the horizontal stabilizer, and fix it together with vertical stabilizer fastener. Put vertical stabilizer into the fastener. Use nipper pliers to bend a 45 bevel of the steel wire L. Glue the rear furrow wheel PVC board to the horizontal stabilizer. 将L形钢丝的一头插入垂直尾翼。在水平尾翼的中间涂胶水，并与垂直尾翼固定块粘合，将垂直尾翼插入垂直尾翼固定块，用尖嘴钳L形钢丝折弯45度，将尾轮支撑PVC板粘合在水平尾翼上。 Use glue to fix landing gear mount, insert landing gear strut and plywood. Fix wheel and put the black plastic pipe onto the axle, use a little glue. 用胶水装配好起落架底座，插入起