舰船建模过程.docVIP

舰船建模技术 技术, structure, generated, computer, currently 舰船建模技术Below are some pictures of my making of French early ships. Im currently working on :- Battleship Hoche- Battleship Bouvet- Armored cruiser Pothuau- Armored cruise Jeanne dArc(each ship at both 1:700 and 1:350 scale)I started from the official Navy plans. I put the files in my computer and extracted the hull frames and longitudinal sections. Heres an example with Hoche : 下载 (95.39 KB)舰船建模技术 1?小时前 then I computer generated the whole hull structure at both scales (again the Hoche) : 下载 (119.87 KB)舰船建模技术 1?小时前 child 发短消息 加为好友 child 当前在线 UID 43662? 帖子 275? 精华 0? 积分 704? 威望 283 ? 金钱 0 ? 在线时间 4 小时? 注册时间 2012-3-19? 最后登录 2012-4-15? I photo etched my project to get a full set of frames and bow + stern structures (Heres Bouvet @ 1:700) : 下载 (65.5 KB)舰船建模技术 半小时前 I assembled both hull parts (I planned a waterline option, hence the two parts). Heres Hoche again : 下载 (28.57 KB)舰船建模技术 半小时前 Then came the filling stage. I used sawn blocks of prototypying board, which is a silica bonded polyurethane resin board used in the industry to make prototypes for casting. This excellent product is worked like balsa wood, but remain stable and watertight for wet sanding. Blocks roughly traced using the brass frames as templates, then roughly cut with an electromagnetic vibrating wire saw and glued in place with Zap-a-Gap, with brass photo etched frames inserted.The sanding step was very easy : one had just to sand the block until the paper touches the brass frames which are harder, making a different noise on them. This rumble noise was the signal to stop. Using this simple way I managed to shape the hulls quickly without using any gauge, template, measurement and I got a shape accuracy about 0.1mm. z 发短消息 加为好友 child 当前在线 UID 43662? 帖子 275? 精华 0? 积分 704? 威望 283 ? 金钱 0 ? 在线时间 4 小时? 注册时间 2012-3-19? 最后登录 2012-4-15? Heres Hoche before and after : 下载 (53.2 KB)舰船建模技术 半小时前 Heres the 1:3