22-cluster 安装完全版2.0.docVIP

22-cluster 安装完全版2.0 先安装disksuite和oracle软件这部分参阅其他的资料，不要忘记打patch； # cd /cdrom_image/sol_8_sparc_2/Solaris_8/EA/products/DiskSuite_4.2.1/sparc/Packages cd /; sh /cdrom/suncluster_sc31u4_sparc/installer # pkgadd -d . SUNWmdr SUNWmdu [SUNWmdx] optional-pkgs ************************************************************************** SCSI 阵列要更改其中一台主机的scsi-initiator-id,另一台先不开机 方法如下：进入ok提示符下 ok setenv auto-boot? false ok reset-all ok probe-scsi-all 记录显示的阵列中控制器的物理路径，如/pci@4,4000/scsi@3及 /pci@4,4000/scsi@3,1,一下以此为例 ok nvedit 0:probe-all install-console banner 1:cd /pci@4,4000/scsi@3 2:6 scsi-initiator-id interger-property 将scsi-initiator-id改为6 (默认的是7) 3:device-end 4:cd /pci@4,4000/scsi@3,1 5:6 scsi-initiator-id interger-property 6:device-end 7:banner (ctrl+c) ok nvstore ok setenv use-nvramrc? True ok setenv auto-boot? True ok reset-all 至此，两台主机可以同时开机进入操作系统，用format命令可以看到9块硬盘，而且保 证阵列上的8块硬盘在两台主机上的物理路径于逻辑设备名完全一致 ************************************************************************** Sun Cluster软件安装： // metadb 分在slice 7 100mb //. format 建一个大约512M的ufs文件系统, newfs , mount 到 /globaldevices 上 vi /etc/vfstab SC3.0 :eeprom local-mac-address?=false SC3.1 :eeprom local-mac-address?=true If you install SC 3.1 Update3 on Solaris 9 then Solaris Auditing (aka BSM) must be disabled. Remove from /etc/system 把这一句注释掉 set c2audit:audit_load = 1 ************************************************************************** IPMP vi /etc/hostname.hme3 SMPP01 group SMPPipmp therapy up addif SMPP01-qfe1-test -failover deprecated up vi /etc/hostname.hme7 SMPP02-qfe2-test group SMPPipmp -failover deprecated up NAFO # ./pnmset In the following, you will be prompted to do configuration for network adapter failover Do you want to continue ... [y/n]: y How many NAFO groups to configure [1]: Enter NAFO group number [0]: Enter space-separted list of adapters in nafo0: hme0 Checking configuration of nafo0: Testing active adapter hme0... NAFO conf