penmount9084setupandusersmanu.docVIP

PenMount 9084 Setup and Users Manu DMC9000 For Dos V1.0 PenMount 9084 control board is the new control board from Salt, its touch screen controller is DMC9000 that interfaces analog resistive touch screens to a personal computer through its COM port. PenMount 9084 control board is designed to have a small mechanical size in order to be located inside the system easily. Together with PenMount driver counterparts on various, PenMount 9084 control board becomes the most popular touch screen solution worldwide. It’s designed to have LED one board to show the touch status and also bundled with three interface cables, customer only needs to power in 5V to 12V DC power to the board, and via RS-232 interface to computer system, PenMount touch screen solution is in your hand. Resolution: 10 bit (1024*1024) PenMount 9084 Control Board Features: Design for best touch performance and easy configuration Design for best cost arrangement Supporting 1024*1024 pen device resolution Built-in 10-bit A/D converter inside the DMC9000 Fast conversion and transmission, 19200 baud rate fixed Upgraded noise handling mechanism (3 level scheme) Fixed and high speed sampling rate 4-wire and 8-wire touch screen supported RS-232 interface supported 5V to 12V power input Power protection fuse to protect the circuit Touch activated indication LED on board PenMount 9084 Control Board Description JP1: Power cable: 5V to 12V DC power JP2: RS-232 cable connector: PIN1: RTS PIN2: TXD PIN3: RXD PIN4: GND JP3: Touch Screen cable, for 4-wire or 8-wire touch screen SW1: always set at “ON” for 4-wire or 8-wire touch panel PenMount 9084 Control Board Hardware Installation Connect the RS-232 cable to JP2 on the control board. Connect the RS-232 cable’s DB-9 female connector to a nine pin serial COM port on the back of the computer. Connect the touch screen to th