section237324–customairhandlingunitswithfan.docVIP

SECTION 23 73 24 – CUSTOm Air Handling Units with fan array systemS GENERAL RELATED DOCUMENTS Drawings and general provisions of the Contract, including General Conditions and Division 01 Specification Sections, apply to this Section. Specifications throughout all Divisions of the Project Manual are directly applicable to this Section, and this Section is directly applicable to them. SUMMARY Perform all Work required to provide and install factory assembled, custom-built air handling units, including factory installed fans, dampers, filters, coils, motors and any specialty equipment as indicated or noted in the Contract Documents with supplementary items necessary for proper installation. This Specification applies to custom air handling equipment on the Drawings identified to be equipped with fan array sections. REFERENCE STANDARDS The latest published edition of a reference shall be applicable to this Project unless identified by a specific edition date. All reference amendments adopted prior to the effective date of this Contract shall be applicable to this Project. All materials, installation and workmanship shall comply with the applicable requirements and standards addressed within the following references: AMCA 99  Standards Handbook. AMCA 210  Laboratory Methods of Testing Fans for Rating Purposes. AMCA 300  Test Code for Sound Rating Air Moving Devices. AMCA 301  Method of Publishing Sound Ratings for Air Moving Devices. AMCA 500  Test Methods for Louver, Dampers, and Shutters. ARI 260 - Sound Rating of Ducted Air Moving and Conditioning Equipment ARI 410  ForcedCirculation Air-Cooling and Air-Heating Coils. ARI 430 – Standard for Central Station AirHandling Units ARI 610  Central System Humidifiers. NFPA 70  National Electrical Code. NFPA 90A - Standard for the Installation of Air-Conditioning and Ventilating Systems. NFPA 262 - Standard Method of Test for Flame Travel and Smoke of Wires and Cables for Use in Air-Handling Spaces. SMACNA