远程登陆.pptVIP

LAN Connections Accessing Remote Devices Using Telnet to Connect to Remote Devices Viewing Telnet Connections Viewing SSH Connections Suspending and Resuming a Telnet Session Closing a Telnet Session Using the ping and traceroute Commands Summary Once connected to a remote device, you may want to access a local device without terminating the Telnet session. Telnet allows temporary suspension and then resumption of a remote session. Ending a Telnet session on a Cisco device uses the exit, logout, disconnect, or clear commands. The ping and trace commands provide information about the connectivity with and path to remote devices. ? 2007 Cisco Systems, Inc. All rights reserved. ICND1 v1.0—4-* ? 2007 Cisco Systems, Inc. All rights reserved. ICND1 v1.0—4-* RouterB# show ssh  Connection?????Version??????Encryption ????State??????????????Username 0??????????????1.5??????????3DES???????????Session Started????guest Tests the connectivity and path to a remote device RouterX#ping 10.1.1.10 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 10.1.1.10, timeout is 2 seconds: !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max = 4/4/4 ms RouterX#trace 192.168.101.101 Type escape sequence to abort. Tracing the route to 192.168.101.101 1 p1r1 (192.168.1.49) 20 msec 16 msec 16 msec 2 p1r2 (192.168.1.18) 48 msec * 44 msec RouterX Emphasize: Another way to learn about a remote device is to connect to it. Telnet, a virtual terminal protocol that is part of the TCP/IP protocol suite, allows connections to remote hosts. By default, a router can have up to five simultaneous incoming Telnet sessions. With Cisco’s implementation of TCP/IP, you need not enter the connect or telnet command to establish a Telnet connection. If you prefer, you can just enter the learned host name, and the router will resolve the host name using DNS or a local host table. To end a Telnet session, use the exit or logout EXEC command. These are alternate commands for the