DSAPSERIES-LED-USPoleCompanyInc.pdfVIP

SOLID STATE AREA LIGHTING DSAP SERIES-LED SPECIFICATIONS HOUSING Upper housing is heavy gauge cast aluminum (DSAP25) or 0.125” thick spun aluminum with reveal (DSAP1). Lower housing is 0.080” thick spun aluminum with integrated LED module seat. Lower housing is vented at top and bottom for convective cooling of LED module. Top Driver chamber is sealed from LED Module chamber. Trulevel ball coupling mount is welded to housing and facilitates quick leveling and installation. ? OPTICS Low copper A356 alloy (.2% copper) cast aluminum housing. Integrated clear tempered 3/16 glass lens sealed with a continuous silicone gasket protects emitters (LEDs) and emitter Re?ector-Prism optics, and seals the module from water intrusion and environmental contaminants. Module is sealed to meet an IP67 rating. LED’s are available in standard Neutral White (4000K), or optional Cool White (5000K) or Warm White (3000K). Each emitter is optically controlled by a Re?ector-Prism injection molded from H12 acrylic (3 types per module; one from 0° - 50°; one from 50° - 65°; one from 65° - 72°). Each Re?ector-Prism has indexing pins for aiming and is secured to an optical plate made of matte black anodized aluminum. The optical plate locates every Re?ector-Prism over an emitter. Re?ector-Prisms are secured to the optical plate with a UV curing adhesive. The Re?ector-Prisms are arrayed to produce IES Type II, III, IV, and V-SQ distributions. The entire Optical Module is ?eld rotatable in 90° increments. Both module and drivers are factory wired using water resistant, insulated cord. Lens, module and drivers are ?eld replaceable. LED DRIVER Drivers are UL and cUL recognized mounted on a single plate and factory prewired with quick-disconnect plugs. Constant current driver is electronic and has a power factor of 0.90 and a minimum operating temperature of -40°F. Drivers accept an input of 120-277V, 50/60Hz. (0 - 10V dimmable driver is standard. Driver has a minimum of 3KV internal surge protection