路面的设计标准轴载累计作用次数程序的设计.docVIP

附录 程序设计 标准轴载累计作用次数程序设计 基于毕业设计需求，为了简化水泥路面计算过程，同时也完成了毕业设计中程序编 写的任务，作者用C 语言编写了《标准轴载累计作用次数程序设计》进行设计年限 内标准轴载累计作用次数的计算。本程序采用JTG D40-2011水泥路面设计规范，各参数取值满足规范要求。 运行时，请按提示输入指定的内容后按Enter，直至出现运行结果，到End表示程序运行结束。 1 程序设计： #includemath.h main() {doubleNs,Ne,Pq[]={11.5,16.5,28.7,25.75,28.7,23.7,49,50.2,60}, Ph[]={23,23,68.2,59.5,69.2,69.2,101.6,104.3,100},d, pro[], sum, a, c, gr; int lane, i, t,N[]; char b; sum=0; d=1; printf(Please put in someparameters.\n); printf(Volume of traffic: \n); printf(minivan:\n); scanf(%d,N[0]); printf(microbus(SH130):\n); scanf(%d,N[1]); printf(big bus(CA50):\n); scanf(%d,N[2]); printf(small truck(BJ130):\n); scanf(%d,N[3]); printf(medium truck(CA50):\n); scanf(%d,N[4]); printf(medium truck(EQ140):\n); scanf(%d,N[5]); printf(big truck(JN150):\n); scanf(%d,N[6]); printf(large truck(KB222):\n); scanf(%d,N[7]); printf(trailer:\n); scanf(%d,N[8]); printf(please put in growth rate, like 0.085:\n); scanf(%f,gr); printf(Please put in number of that how many traffic lane the highwayhave:\n); scanf(%d,lane); if(lane=4) {printf(Please choose a number between 0.5-0.75. \n); scanf(%f,a);} else { swith(lane) {case1: a=1.0; case2: {printf(Please choose a number between 0.8-1.0. \n); scanf(%f,a); break; } case3: {printf(Please choose a number between 0.6-0.8. \n); scanf(%f,a); break; } default: printf(error\n);break; } } printf(Please choose your highway classificatian as A, B or C: \n) printf(A: expressway, senior road, fee sation \n) printf(B: junior road(lane width more than 7m)\n:) printf(C: junior road(lane width amount to 7 or less than 7m)\n:) b=getchar(); swith(b) {caseA: {printf(Please choose a number between 0.17-0.22. \n); scanf(%f,c); t=30; break; } caseB: {printf(Please choose a number between 0.34-0.39. \n); scanf(%f,c); t=20; break; } caseC: {printf(Please choose a number between 0.54-0.62. \n); scanf(%f,c); t=20; break; } default: printf(error\n);break; } for(i=0;i=8;i++) { d=2.22*pow10(3)*pow(Pq[i],-0.43); pr