病床呼叫plc素材.docxVIP

电气控制技术课程设计说明书病床呼叫系统设计院 、 部：电气与信息工程学院学生姓名：刘潼指导教师： 陈华容 职称 高级实验师 专 业：电气工程及其自动化班 级：电气本1305学 号：1330120535完成时间：2016年6月摘要随着科技的发展，智能化的医院建设的将目前国内外先进的计算机技术、通信技术、网络技术、信息技术、自动化控制技术、办公自动化技术等运用在医院中。而目前国内外的呼叫器系统都选用无线网络，受到地域的限制和环境的限制。信号接收不是很好，这样有可能病人会呼叫不到医生，造成病人病情的恶化。基于可编程控制器设计病床呼叫系统，该控制系统主要有硬件和软件两部分组成。硬件电路的设计，根据设计要求进行了PLC的选型和警报器的选择，设计了病床呼叫系统外部接线图。在系统软件设计方面，采用了GX Developer软件对程序进行编写和调试，将病床呼叫系统分为了六个模块：启动模块、复位模块、输入模块、输出模块、指示灯模块、电铃模块。本设计中病床呼叫系统有利于对医院的发展和方便病人 ，使得医院医疗更人性化，提高医院工作效率，而此系统拥有良好的前景。关键词：可编程控制器（PLC）；病床呼叫系统；病房管理ABSTRACTAlong with the development of science and technology, intelligent hospital construction at home and abroad will be the advanced computer technology, communication technology, network technology, information technology, automation control technology, the use of office automation technology in hospital. And at present at home and abroad of the pager system use wireless network, subject to geographical constraints and environmental constraints. Signal reception is not very good, which is may patients may be less than calling a doctor, resulting in deterioration of the patient.Based on programmable controller design Sickbed Calling the system. The control system mainly consists of two parts of hardware and software. Hardware circuit design, according to the design requirements were the selection of PLC and alarm, the design of the sickbed calling system, the external wiring diagram, in the design of system software, the GX Developer Software program for writing and debugging, the sickbed calling system is divided to six modules: starting module, reset module, input module, output module, indicating lamp module, buzzer module.Hospital bed call system is conducive to the development of the hospital and the convenience of patients, makes the hospital medical more humane, improve hospital efficiency, and this system has a good prospect.Key words: programmable logic controller (PLC); hospital bed system; ward management目录1 绪论11.1 病床呼叫系统的概念11.2 呼叫系统的现状11.3 病床紧急呼叫系