音乐喷泉毕论设文2.docVIP

摘 要 随着社会生活的发展，人们日常生活的水平逐渐提高，人们的审美需求也渐渐高涨起来，城市生活中的音乐喷泉已经渐渐趋于平常化、大众化以满足人们日益增长的审美需求，这就要求我们应该对音乐喷泉这一艺术形式进行较为深入的分析和研究。 本文针对音乐喷泉这一系统，首先，介绍了音乐喷泉的发展现况，工作原理和形成过程，紧接着介绍了我所设计的音乐喷泉在proteus仿真开发环境下的电路图；其次，为使读者能理解其在本设计中的工作原理，介绍单片机的各项知识，包括单片机的内部结构和引脚等；接着，介绍了设计中使用的继电器和电磁阀的各方面知识，包括各自的分类、工作原理和参数以及各自的选用时的注意事项和故障排除等。最后，还介绍了在keil开发环境下单片机的C语言原程序。 关键词： 音乐喷泉 proteus 单片机 继电器 电磁阀 keil ABSTRACT Along with the development of social activities, daily life of the peo-ple level gradually improve, peoples aesthetic demand also gradually rise, city life in the music fountain has gradually become popular, popularin order to meet the growing needs of peoples aesthetic needs, this re-quires that we should to the music fountain this art form to carry on amore thorough analysis and research. The music fountain this system, firstly, introduces the current situation of the development of music fountain, working rinciple and process of forming, followed by introduction of I design the music fountain simulation development environment in the circuit diagram; secondly, to enable readers to understand the design principle of work, the introduction of SCM knowledge, including the internal structure of single and pin; then, the design introduced the use of the relay and the electromagneticvalve in all aspects of knowledge, including their classification, workingprinciple and parameters as well as their choice of cautions and troubleshooting. Finally, it also introduced the development environment in keilsinglechip C language program. Keyawords: music fountain Proteus single chip micro-computerrelay electromagnetic valve Keil 目录 第一章 绪论 1 1.1 音乐喷泉概述 1 第二章 总体设计 3 2.1 产生音乐 3 2.2产生水柱 3 2.3驱动环节 3 2.4 电路图及其分析说明 4 第三章 单片机部分结构功能简介 7 3.1 单片机的概念 7 3.2 单片机芯片内部结构 8 3.3 主要常用引脚 11 3.4 STC89C52单片机简介 13 第四章 继电器介绍 15 4.1 继电器概述 15 4.2 继电器工作原理 15 4.3 继电器元件符号 15 4.4 器件作用 15 4.5 继电器的分类 16 4.6 继电器的选用条件 16 4.7 继电器的选用注意事项 17 4.8 继电器的动作时间问题 18 4.9 继电器与接触器的区别 20 第五章 电磁