新型改性纤维填料的油水分离过程研究.pdf

第九届全国非均相分离技术学术交流会论文集 新型改性纤维填料的油水分离过程研究 丰兰1 康勇2 (1．国防科工委颗粒度计量一级站，新乡，453019；2．天津大学化上学院，天津，300072) 摘要本文针对含油污水设计制作了一套内置新型改性纤维填料的立式油水分离器：考察该油水分离器进 口流速和污水含油浓度对处理后出水油含量和除油效率的影响，并分析了污水含油浓度对油滴脱除粒径的 影响。研究结果表明，进El流速小于2L／min时，出水含油浓度随之缓慢增加，月．除油效率均在90％以E： 可以达到4．6mg／L．纤维填科对油滴粒径大于10I．tm的脱除效率达到了96％以上。 关键词油水分离器；纤维滤床；含油污水 011 rationEffectofOiiandWater StudySepa withaNewSurface．ModifiedFibers Lan‘ Feng KangVong ofScience and forNationalDefence of (1．CommissionTechnologyIndustry First-OrderStation Particle ofChemical Measurement，Xinxiang413019；2．SchoolEngineeringofTianjin 300072) University,Tianjin Abstract：Averticaloilwater witha surfacenature fiber，was separator,fillednewly changed totreat wastewater．Onthe influenceoffluid andinfluent designed oily basic，the velocity concentrationand ofoilremovaltobe concentrationoneffluent efficiency began measured，the to ofthediameteroftheoil inwastewaterWas influenceoftheoilconcentrationtheremoval drop the increaseoftheeffluentconcentrationwasslowwhen shows，the analysed．Theexperiment fluid ofinletvariedfrom0L／minto2L／rain．andthe ofoilremovalwouldbe Velocity efficiency effluentconcentrationcouldreachto theinfluent morethan90％：the 4．6mg／L．when concentrationvariedfrom to1 andthefluid ofinletwassetat