电磁铁使用说明书探析.docVIP

目 录Index 1、基本原理和使用条件 Basic principle and operating conditions 2、产品型号及含义 Models and contents 3、用途及使用范围 Usage and applicable range 4、结构及特点 Structure and characteristic 5、电气性能 Electrical property 6、型号、技术参数与外形尺寸图 Models, technical data, and overall dimension drawing 7、使用注意事项 Cautions 8、保养及维修 Maintenance and service 1.基本原理和使用条件 Basic principle and operating conditions 1.1 基本原理 Basic principle 电磁铁工作时，电源及控制设备向电磁铁供给直流电，电磁铁内部产生强大的磁场，通过壳体磁路和工作气隙对被吸物产生强大磁力而达到搬运物料的目的。 When electromagnet works, the power source and the controlling device supply direct current to the electromagnet. A strong magnetic field will be generated inside the electromagnet, the magnetic field gives enough strong magnetic force on the material through the shell magnetic circuit and the operating clearance to lift the bulk material . 1.2 使用条件 using conditions 1.2.1 使用地点的海拔高度不超过2000m。 Not more than elevation of 2000m 1.2.2 周围空气温度：Surrounding air temperature 常温型：不高于+40℃，不低于-20℃。 Normal temperature type -20℃ ~ +40℃ 高温型：不高于+50℃，不低于-20℃。 High temperature type: no more than +50℃,no less than -20℃ 1.2.3 周围工作环境无爆炸危险和不含有腐蚀性气体的环境中。 No explosive dangerous or corrosive gas around the magnet. 1.2.4 周围环境相对温度不大于85%。 The relative humidity is not more than 85% 1.2.5 户外、户内均可使用。Both outdoors and indoors. 2.产品型号说明：Model Designations 注：MW1系列起重电磁铁散料型产品使用说明书同MW5系列。The MW1 series lifting electromagnet manual is the same as the MW5 series。 3.用途及使用范围 Usage and applicable range 3.1 用途 Usage 该系列电磁铁广泛应用于冶金、铸造、机械制造、交通运输等部门，与起重设备配套，作为装卸搬运生铁、废钢等铁磁性物料之用。 This series electromagnet is widely applied to metallurgy, casting, machine manufacture, transportation and so no ,forming complete set with lifting equipment equipments to carry out loading and handling the magnetic material such as pig irons and scrap steel. 3.2 适用范围 Applicable range 本起重电磁铁适用于直流额定工作电压为220V，常温型起重电磁铁被吸物表面温度100℃以下，高温型起重电磁铁被吸物温度600℃以下。This lifting electromagnet is suitabl