CHROMA8000.pptVIP

* Provide Clean and regulated output voltage(s) under specified line-in or loading condition. Output Performances Output(s) Regulation Input Characteristics Protection circuit Timing And Transient Other special features Chroma SPS ATS - 8000 test items : Output performances : Output voltage/Output current/Output power/Peak-Peak noise RMS noise/Current ripple/Overshoot voltage/Efficiency Output(s) regulation : Line regulation/Load regulation/Cross regulation/Combine regulation/Total regulation/Current regulation Input characteristics : Inrush current/IRMS current/Peak current/Power/Power factor/ Voltage ramp/Frequency ramp/Current harmonics against regulations/AC cycle drop out/PLD simulation Timing and Transient : Turn on time/Rise time/Fall time/Hold-up time/Power up/Power off/Transient response time/Tracking/Swing/Extra timing Line-in Loading Output voltage Protection circuit : Short circuit/Short circuit current/OV protection/UV protection/OL protection/OP protection/Fan speed Special features : I2C read(write)/RS232 read(write) /RS485 read(write)/Auto alignment /TTL signal control/Relay control /Correlation test/Barcode scan/ UUT measurement verification Hardware devices for power supply testing : AC Source DC Source Power Analyzer Electronic Load Timing Measurement Device Transient Measurement Device DIO Relay Matrix On/Off Control Inrush Meas. Device OVP/Short Circuit Simulator Testing Fixture System controller Chroma SPS ATS Model 8000 Hardware Configuration AC Source - 6500/6400/61500/61600 series DC Source - 6200/6210K/6210F series Power Analyzer - 6630/6632 series Electronic Load - 6300/6310/6320/6340 series Timing/Noise Analyzer - 6011(With DIO Relay matrix) OVP/Short Circuit Tester - 6012 (With programmable impedance) On/Off Controller - 6013 (With inrush current measurement) Digital Storage Oscillate Scope - TDS 3012/3014 (Option) Digital Multi-Meter - HP 34401A (Option) Testing Fixture System controller - PC/IPC Chroma AC Source Chroma D