思科网络技术培训之：连接Cisco设备.pptVIP

Objectives Upon completion of this chapter, you will be able to perform the following tasks: Identify and connect necessary components to enable connectivity between routers or switches Identify and connect necessary components to enable WAN connectivity over serial or ISDN BRI connections Objectives (cont.) Set up console connections between routers, switches and a terminal Document the physical topology, including cable types and cable locations on each internetworking device Cabling the Campus Positioning Ethernet in the Campus Differentiating between Connections UTP Device UTP Implementation Straight-through UTP Implementation Crossover UTP Implementation of Straight-through versus Crossover Cabling the Campus Cabling the WAN Serial Implementation ofDTE versus DCE DTE/DCE—The point where responsibility passes Modular Interfaces Cabling Routers for ISDN Connections Cabling Routers for ISDN Connections (cont.) Setting up a Console Connection Summary After completing this chapter, you should be able to perform the following tasks: Identify and connect necessary components to enable connectivity between switches and routers Identify and connect necessary components to enable WAN connectivity between over serial or ISDN BRI connections Set up console connections on routers and switches Document the physical topology of a network, including cable types and locations Review Questions 1. Discuss three standards on which Ethernet LAN implementations are based. 2. If you want to upgrade your switch to switch connectivity to 100BaseT, what category of cable do you need? 3. Does the following pinout scheme reflect a straight-through, rollover, or crossover cable? 4. What media can be used for each connector type? Purpose: Review the chapter with open ended questions. Note: The questions in this section are open ended questions designed to foster further discussion. Answers the the review questions are in the “Answers” appendix. Purpose: This chapter r