CiscoIOSIS-ISforIPv.ppt

Cisco IOS IS-IS for IPv6 Patrick Grossetete Cisco Systems Cisco IOS IPv6 Product Manager pgrosset@ Agenda IS-IS standardization Cisco IOS IS-IS for IPv6 Cisco IOS Multi-Topology IS-IS IPv6 Routing Protocols Same “longest-prefix match” routing as IPv4 CIDR Two Different Classes Link-State (i.e., OSPF, ISIS, etc.) Distance-Vector (i.e., RIP, IGRP, etc.) Autonomous System / Routing Domain Interior Gateway Protocols (IGPs) i.e., OSPFv3, ISIS for IPv6, RIPng, EIGRP for IPv6 Exterior Gateway Protocols (EGPs) Multi-Protocol Extensions for BGP4 IS-IS Standards IETF IS-IS for IP Internets WG /html.charters/isis-charter.html ISO 10589 specifies OSI IS-IS routing protocol for CLNS traffic Tag/Length/Value (TLV) options to enhance the protocol A Link State protocol with a 2 level hierarchical architecture. RFC 1195 added IP support, also known as Integrated IS-IS (I/IS-IS) I/IS-IS runs on top of the Data Link Layer Requires CLNP to be configured Draft RFC defines how to add IPv6 address family support to IS-IS /internet-drafts/draft-ietf-isis-ipv6-05.txt Draft RFC introduces Multi-Topology concept for IS-IS /internet-drafts/draft-ietf-isis-wg-multi-topology-06.txt IS-IS for IPv6 2 Tag/Length/Values added to introduce IPv6 routing IPv6 Reachability TLV (0xEC) External bit Equivalent to IP Internal/External Reachability TLV’s IPv6 Interface Address TLV (0xE8) For Hello PDUs, must contain the Link-Local address For LSP, must only contain the non-Link Local address IPv6 NLPID (0x8E) is advertised by IPv6 enabled routers Agenda IS-IS standardization Cisco IOS IS-IS for IPv6 Cisco IOS Multi-Topology IS-IS Cisco IOS IS-IS for IPv6 IS-IS for IPv6 was introduced across Cisco IOS releases 12.2(8)T and above as well as Cisco 12.3M on Cisco 2600 to Cisco 7500 series 12.0(22)S and above on Cisco 12000 12.2(14)S and above on Cisco 7x00 series and Cat.6K [12.2SX] Images are –p and –js as CLNS is required for IS-IS A single SPF runs per level for OSI, IPv4 and IPv6 All routers in an a