C11 Best Effort Traffic Control Algorithm.pptVIP

Huawei Profile Best Effort Traffic Control Algorithm 2004-03 DCCC Why DCCC What is DCCC How to DCCC Why DCCC Uu code resource is limited Iub/Iu band resource is limited 3G best effort traffic attribute What is DCCC DCCC: Dynamic Channel Configuration Control aim: make full use of radio resource (also Iub/Iu) How to DCCC Traffic Volume Measurement Measurement Parameters Traffic volume measurement 4a Threshold Time to trigger Pending time after trigger 4b Threshold Time to trigger Pending time after trigger DCCC decision If DCCC switch is on,initial rate is full coverage rate When 4a event - increase bandwidth When 4b event - decrease bandwidth Set DCCC threshold,if current bandwidth=DCCC threshold,don’t decrease bandwidth If in SHO state,take into account SHO threshold rate DCCC execution Why Link Quality Check Because of DL code and power resource is limited,high bit rate traffic such as 384k can’t covered somewhere,if the UE move to this place the call will drop.Using Link Quality Check,the PS traffic can be covered continuously as following. How to Link Quality Check DL Transmitted Code Power Measurement Tx Code Power Measurement Parameter Event E Ea relative threshold Eb relative threshold filter coefficient hysteresis time report period Link Quality Check decision and execution If DL Transmitted Code Power event Ea is triggered,decreasing DL bandwidth and start a timer when DCCC switch is off . If the timer elapses,resume the bandwidth. UE State Transitions Why UE state transitions Save radio resource Save UE power and battery CELL_DCH ? CELL_FACH Traffic volume measurement In CELL_DCH, If in a given period the times of zero traffic volume report reaches a given threshold, doing CELL_DCH → CELL_FACH In CELL_FACH, if 4a event is triggered, doing CELL_FACH → CELL_DCH CELL_FACH → CELL_PCH Traffic volume measurement If in a given period the times of zero traffic volume report reaches a given threshold, doing CELL_FACH →CELL_PCH CELL_PCH → URA_PC