生产过程中般瑕疵英文辞汇.docVIP

生産過程中一般瑕疵英文辭彙 ? (a)?? 制鞋面一般瑕疵 stitch marking is wrong .針車記號不正確. Linings are not trimmed well enough .內裏修得不夠好. Enamel is coming off eyelets. 鞋眼掉漆. Not enough pressure on sewing MA. 針車壓力不夠. Shoe is skived incorrectly .削邊不正確. Folding is not good enough. 拗邊拗得不好. Too much pressure on machine .針車壓力太大. Eyelets are loose must be tight. 鞋眼鬆動需緊合. Not enough stitches per inch. 針碼不足. Must use washer with eyelet 鞋眼須加墊圈. Too many stitches per inch .針碼太密. Size of thread is wrong 車線的粗細不對. Stitching too close to edge 針距太近邊沿 Round corners are being stitched square 圓形轉角車成方形 Tip is not stitched on mark-wrong position . 鞋頭未按記號針車. Must use reinforcement tape 必須使用加強帶. Outside counter not stitched in correct position. 後包片未按記號針車. Reinforcement tape is not in right place. 加強帶未放於正確位置上 Too many wrinkles in collar lining 滾口內裏太多皺紋 Foam is not heavy enough 泡棉太薄 Upper is damaged because of poor trimmed foam lining.修內裏時修到了鞋面,致使鞋面受損. Binding is not stitched correctly. 滾邊不好. Tongue label is not in right location. 鞋舌位元商標錯誤. Holes are not punched properly. 洞打得不適合. Leather is not good . 皮料不好. The punched holes must be cleaned out . 鞋眼洞應打透並清理乾淨. Needles are too big .針太大 Bobbin thread is in wrong color and must be the same as the top.底線用錯,顔色應與上端線同色. Collar not stitched in center. 領口未車於中心. Thread is not strong enough 針車線不夠結實 Collar lining is not cemented correctly. 內裏未貼著良好. The perforation is too high. 鞋口接合太深. Tongue are stitched in the center of eyestay. 鞋舌未接合於鞋眼片中央. Eyelets are too big. 鞋眼太大 Eyelets are too small . 鞋眼太小. Tongue is stitched in too low. 鞋舌接合太淺. Edge of material must be stained 材料邊沿必須塗邊處理. Lasting allowance stitch is too far from edge . 邦腳車線邊距太遠. Thread is not correct color. 車線顔色不對. Printing is not clear enough .印刷不清晰. (b)?? 成型一般瑕疵 angle on insole 中底發角?????????????????????? backstrap too high 後帶太高 backstrap too low 後帶太低???????????????????? backstrap too long 後帶太長 backstrap too short 後帶太短??????????????????? backstrap too loose 後帶太松 backstrap too tight 後帶太緊??????????????????? cementing come