设计指南晒纹篇.docVIP

Design Guidelines-Choosing a surface finish/设计指南-晒纹篇 2007-4-28 17:22:41 When designing a part for injection molding, it is important to keep in mind the relationships between surface finish, moldability, cost and lead time. 当设计一个组成部分注塑,这是很重要的,记住这一关系表面处理,moldability、成本和交货时间。Figure 1 contains the list of standard surface finishes available through Protomolds rapid injection molding service, listed in order from lowest to highest cost. 图1包含串标准化的表面镀层可通过Protomold的快速成型服务依次从低到高的成本。 Figure 1: List of available standard finishes Higher Cost PM-F0: Non-cosmetic—finish to Protomold discretion PM