配置动态NAT.docVIP

配置动态NAT 路由器和PC的基本配置 Routerenable Router#configure terminal Enter configuration commands, one per line. End with CNTL/Z. Router(config)#host R1 R1(config)# R1(config)#interface FastEthernet0/1 R1(config-if)#ip address 192.168.1.1 255.255.255.0 R1(config)#interface FastEthernet0/1 R1(config-if)#no shutdown %LINK-5-CHANGED: Interface FastEthernet0/1, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to up R1(config-if)# R1(config-if)#exit R1(config)#interface FastEthernet0/0 R1(config-if)#ip address 218.12.226.1 255.255.255.0 R1(config-if)#no shutdown %LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up R1(config-if)# %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up R1(config-if)#exit R2 Routeren Router#conf t Enter configuration commands, one per line. End with CNTL/Z. Router(config)#host R2 R2(config)# R2(config)#interface FastEthernet0/0 R2(config-if)#ip address 218.12.226.2 255.255.255.0 R2(config-if)#no shutdown %LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up R2(config-if)# 在路由器R1上配置动态NAT R1(config)#interface FastEthernet0/1 R1(config-if)#ip nat inside R1(config-if)#exit R1(config)# R1(config)#interface FastEthernet0/0 R1(config-if)#ip nat outside R1(config-if)#exit R1(config)#ip nat pool cyj 218.12.226.3 218.12.226.4 netmask 255.255.255.0 //配置动态NAT转换的地址池 ipnat_addrpool_notify_api: id , flags 11, range 0 ipnat_addrpool_notify_api: id , flags 11, range 1 R1(config)#access-list 1 permit 192.168.1.0 0.0.0.255 //允许动态NAT转换的内部地址范围R1(config)#ip nat inside source list 1 pool cyj //配置动态NAT映射ipnat_remove_dynamic_cfg: id 1, flag 9, range 0 ipnat_add_dynamic_cfg: id 1, flag 11, range 0 poolstart 218.12.226.3 poolend 218.12.226.4 id 1, flags 0, domain 0, lookup 0, aclnum 1 , aclname 1 , mapname idb 0 R1(config)#ip route 0.0.0.0 0.0.0.0 218.12.226.1 //配置默