宝灵市污水处理厂初步设计_学位论文.docVIP

灵宝市污水处理厂初步设计 摘要 根据根据洛阳理工学院土木工程系下达的设计任务，对灵宝市污水处理进行设计计算。经综合考虑后，本设计主体处理构筑物采用氧化沟，经过处理后使污水达到所需水质要求。 通过市政管网收集的污水在通过粗格栅去除大的悬浮杂质后，由提升泵站将污水提升到污水处理厂。在经过细格栅后，进入平流式沉砂池将污水中较大的无机颗粒去除。而后进入氧化沟，利用活性污泥对污水进行脱氮除磷，降低污水中的BOD、COD。处理后的污水进入接触池消毒，达到排放标准。对氧化沟内产生的污泥首先进入浓缩池浓缩，在经带式压滤机压滤脱水后外运填埋。 设计中对整个处理流程的各主体构筑物如格栅、平流式沉砂池、氧化沟、接触池等进行了详细、系统的设计计算和说明。理论上给出了这个流程中BOD、COD、的去除率及脱氮除磷的效率。在泥路中，对浓缩池、脱水机进行设计计算和说明。再结合灵宝市当地的地形和设计规范，对污水处理厂进行平面布置和高程计算，从而系统的确定各处理构筑物的标高及布置。 污水经过各处理构筑物后，达标排放至农灌渠，从而缓解灵宝市的用水危机，并改善灵宝市的环境问题。 关键词：城市污水 改良型氧化沟 生物处理 脱氮除磷 The preliminary design in wastewater treatment plant of Lingbao city Abstract According to the design mission in Department of Civil Engineering of the Luoyang College of science and technology, the calculation is carried out for the municipal sewage in Lingbao. After consideration, the triple oxidation ditch is adopted in this design; the effluent is made to attain the discharge of the urban sewage. After removing the miscellaneous in municipal sewage which is collected by tube net by the thick space grid. Then the municipal sewage is pumped to the plant. After passing the thin bar, the municipal sewage comes into the sand sinking pond to take off the large inorganic substance. Then entering to the oxidation ditch, getting rid of the nitrogen and the phosphor by activated sludge, at the same time BOD, COD is reduced. At last, it comes into the contact pool to antiseptic, making the effluent be up to the standard of the discharge. Collected in the oxidation ditch, the mud is sent to thickener pond first, then it is pressed into piece by the straining dehydrate machine and carried outside. The major content of this design is about the calculation and introduction of main structures such as pump station, grille, desilting basin, contact pond, thickener pond, the oxidation ditch, sludge digestion, sludge impoundment in detail and systematically, which are parts of the procedure. The removal efficiency of BOD, COD, denitrification and phosphorus removal effic