[高清书籍]A0227_A0227M-06机械弹簧用冷拉钢丝.pdf

Designation: A 227/A 227M – 06 Standard Specification for Steel Wire, Cold-Drawn for Mechanical Springs1 This standard is issued under the fixed designation A 227/A 227M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (e) indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the Department of Defense. 1. Scope* 1.1 This specification covers two classes of round cold- drawn steel spring wire having properties and quality for the manufacture of mechanical springs that are not subject to high stress or requiring high fatigue properties and wire forms. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 2. Referenced Documents 2.1 ASTM Standards: 2 A 370 Test Methods and Definitions for Mechanical Testing of Steel Products A 510 Specification for General Requirements for Wire Rods and Coarse Round Wire, Carbon Steel A 510M Specification for General Requirements for Wire Rods and Coarse Round Wire, Carbon Steel [Metric] A 700 Practices for Packaging, Marking, and Loading Methods for Steel Products for Shipment A 751 Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products A 941 Terminology Relating to Steel, Stainless Steel, Re- lated Alloys, and Ferroalloys E 29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications 2.2 American National Standard: B 32.4M Preferred Metric Sizes for Round, Square, Rect- angle, and Hexagon Metal Products3 2.3 Federal Standard: Fed. Std. No. 123 Marking for Shipment