[高清书籍]A0020_A0020M-06压力容器用钢板材通用要求.pdf

Designation: A 20/A20M – 06 Standard Specification for General Requirements for Steel Plates for Pressure Vessels1 This standard is issued under the fixed designation A 20/A20M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (e) indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the Department of Defense. 1. Scope* 1.1 This general requirements specification2 covers a group of common requirements that, unless otherwise specified in the applicable product specification, apply to rolled steel plates for pressure vessels covered by each of the following product specifications issued by ASTM: Title of Specification ASTM Designation3 Pressure Vessel Plates, Alloy Steel, Chromium-Manganese Silicon A 202/A 202M Pressure Vessel Plates, Alloy Steel, Nickel A 203/A 203M Pressure Vessel Plates, Alloy Steel, Molybdenum A 204/A 204M Pressure Vessel Plates, Alloy Steel, Manganese-Vanadium A 225/A 225M Pressure Vessel Plates, Carbon Steel, Low- and Intermediate- Tensile Strength A 285/A 285M Pressure Vessel Plates, Carbon Steel, Manganese-Silicon A 299/A 299M Pressure Vessel Plates, Alloy Steel, Manganese-Molybdenum and Manganese-Molybdenum-Nickel A 302/A 302M Pressure Vessel Plates, Alloy Steel, 9 Percent Nickel Double- Normalized and Tempered A 353/A 353M Pressure Vessel Plates, Alloy Steel, Chromium-Molybdenum A 387/A 387M Pressure Vessel Plates, Carbon Steel, High Strength Manga- nese A 455/A 455M Pressure Vessel Plates, Carbon Steel, for Intermediate- and Higher-Temperature Service A 515/A 515M Pressure Vessel Plates, Carbon Steel, Moderate- and Lower- Temperature Service A 516/A 516M Pressure Vessel Plates, Alloy Steel, High-Strength, Quenched and Tempered A 517/A 517M Pressure Vessel Plates, Alloy Steel, Quenched and Tempe