[高清书籍]A0276-06不锈钢棒材和型材.pdfVIP

Designation: A 276 – 06 Standard Specification for Stainless Steel Bars and Shapes1 This standard is issued under the fixed designation A 276; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (e) indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the Department of Defense. 1. Scope* 1.1 This specification covers hot-finished or cold-finished bars except bars for reforging (Note 1). It includes rounds, squares, and hexagons, and hot-rolled or extruded shapes, such as angles, tees, and channels in the more commonly used types of stainless steels. The free-machining types (Note 2) for general corrosion resistance and high-temperature service are covered in a separate specification. NOTE 1—For bars for reforging, see Specification A 314. NOTE 2—For free-machining stainless bars designed especially for optimum machinability, see Specification A 582/A 582M. NOTE 3—There are standards covering high nickel, chromium, austen- itic corrosion, and heat resisting alloy materials. These standards are under the jurisdiction of ASTM Subcommittee B02.07 and may be found in Annual Book of ASTM Standards, Vol. 02.04. 1.2 The values stated in inch-pound units are to be regarded as the standard. 2. Referenced Documents 2.1 ASTM Standards: 2 A 314 Specification for Stainless Steel Billets and Bars for Forging A 370 Test Methods and Definitions for Mechanical Testing of Steel Products A 484/A 484M Specification for General Requirements for Stainless Steel Bars, Billets, and Forgings A 582/A 582M Specification for Free-Machining Stainless Steel Bars A 751 Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products E 527 Practice for Numbering Metals and Alloys (UNS) 2.2 SAE Document:3 SAE J 1086 Recommended Practice fo