9701_w09_qp_31.pdfVIP

This document consists of 11 printed pages and 1 blank page. SJF4880/SJF 17555/2 ? UCLES 2009 [Turn over UNIVERSITY OF CAMBRIDGE INTERNATIONAL EXAMINATIONS General Certificate of Education Advanced Subsidiary Level and Advanced Level READ THESE INSTRUCTIONS FIRST Write your Centre number, candidate number and name on all the work you hand in. Give details of the practical session and laboratory where appropriate, in the boxes provided. Write in dark blue or black pen. You may use a soft pencil for any diagrams, graphs or rough working. Do not use staples, paper clips, highlighters, glue or correction fluid. DO NOT WRITE IN ANY BARCODES. Answer all questions. You are advised to show all working in calculations. Use of a Data Booklet is unnecessary. Qualitative Analysis Notes are printed on pages 11 and 12. At the end of the examination, fasten all your work securely together. The number of marks is given in brackets [ ] at the end of each question or part question. * 5 0 1 4 4 9 2 6 8 9 * CHEMISTRY 9701/31 Paper 31 Advanced Practical Skills October/November 2009 2 hours Candidates answer on the Question Paper. Additional Materials: As listed in the Confidential Instructions For Examiner’s Use 1 2 Total Session Laboratory 29701/31/O/N/09? UCLES 2009 BLANK PAGE 39701/31/O/N/09? UCLES 2009 [Turn over For Examiner’s Use 1 You are provided with the following reagents. ? two weighing bottles labelled FA 1, each containing between 2.90 g and 3.00 g of zinc powder ? FA 2, 0.80 mol dm–3 copper sulfate, CuSO4 You are to determine the enthalpy change, ΔH, for the following reaction. Zn(s) + CuSO4(aq) Cu(s) + ZnSO4(aq) You will carry out the experimental procedure twice. Read through the instructions below before starting the experiment. (a) You will weigh each bottle and later in the experiment weigh it again after the zinc powder has been tipped into copper sulfate solution. In the space below prepare a table to record the weighings and the mass of zinc