自选电视遥控器外壳模具设计及分析 毕业设计.docVIP

浙 江 科 技 学 院 本 科 毕 (2013届) 题 目 学 院 专 业 班 级 学 号 学生姓名 指导教师 完成日期 对塑件的尺寸进行计算，确定尺寸精度，然后进行注射机的选取。对注射机参数进行校核，各个参数都满足要求后确定注射机。在设计过程中，为了更清楚的表达模具的内部结构，Design and analysis of TV remote shell mold Student: ShengQiang Zhou Advisor: Dr.wangchan School of Mechanical and Automotive Engineering Zhejiang University of Science and Technology Abstract This design is the design of injection mould for the cabinet. The design uses two mold cavity, type of the sprue is latent gate, the parting surface is chosen in the maximum section of the plastics. After plastics are molded， molding products are driven by putting from dynamic model,then using reset stem returned. In the design ,the size of the plastic parts needed to calculate ,then determine the size precision and select the type of injection moulding machine. Checking the parameters of injection machine, including the thickness of mold closing,the size of mould installation,the trip of opening mold ,the clamping force of injection machine,and so on. Determining the model of injection machine after each parameter are meet the requirements. Finally use the PROE software to mill out molding parts. In the design process , in order to express the internal structure of mould clearly，there have a lot of mould structure and mould local charts ，then throproeh CAD and proe software plot its 3d stereo. Keywords： Cabinet Parting,surface Runner Process analysis 目录 摘要 i Abstract ii 目录 iii 第一章 绪论 1 第二章 塑件分析 2 2.1 塑件结构 2 2.2 制品质量 3 2.3 尺寸精度 3 第三章 材料的选择与工艺性分析 4 3.1 注塑成型工艺简介 4 3.2 塑件材料选择 5 3.2.1 材料ABS的注塑成型参数 5 3.2.2 材料ABS性能 5 第四章 拟定模具结构形式 7 4.1 分型面位置的确定 7 4.2 型腔数量的确定 8 第五章 注塑机的选择及校核 9 5.1 选择注塑机 9 5.2 注塑机的校核 10 5.2.1 最大注塑量的校核 10 5.2.2 锁模力的校核 10 5.2.3 塑化能力的校核 10 5.2.4 喷嘴尺寸校核 10 5.2.5 定位圈尺寸校核 11 5.2.6 模具外形尺寸校核 11