Typicalgeneratorsetsinstallationguidelines.docVIP

Typical generator sets installation guidelines AA)Generator sets room layout1.if there is enough space at site,it is preferable to mount the genset in row than in column.2.the output terminals should be closely with distribution room when genset and control room are adjoin.3.put the batteries near to start motor side.4.the air inlet opening should be set aside the generator end,sufficient space must be left for it.exhaust gasshould be ventilated outside the room,and its opening should near the radiator.5.genset noise silencing materials and acoustic enclosure around the room should work together for reducingnoiseIllustration A-1BB)Installation1.on reinforced concrete foundationgenset should be mounted on a reinforced concrete which past one month of 173kPa pressure test.thefoundation should be at least 150mm above ground level and have a minimum 150mm extention on each sides,there should be J or L type anchor bolts pre-mounted.2.on base oil tankthe engine and generator should be mounted on a common base fuel tank through vibration dampers,the base tankcan withstand both static load and dynamic load of genset,leave a necessary clearance for future service.3.on vibration isoulation foundationsimilar performance with item1Illustration B-1 CC)Intake and exhaust system1.use support bracket for exhaust pipe and turbocharger2.a bellow is prohibited for compensating installation error or used as an elbow 3.choose 610mm or above bellows for 200kW or above gensets4.horizontal exhaust pipe should be slightly sloped downward 0.3-0.5% grade towards outside,arrangea drain valve at the lowest point5.arrange a drain plug at the lowest point if the exhaust pipe must be sloped upward.6.never use exhaust pipes with dimension less than the exhaust manifold7.special attention should be taken for shared exhaust pipeIllustration C-1DD)Cooling system1.ventilation inlet opening should be arranged at the end of or near the alternator,area should be