lcd显示器控制电路.doc

桂林电子科技大学实训说明书用纸 PAGE  PAGE 15 井冈山大学 课程：电子测量 系别：电子工程系 班级：08电信本（1） 姓名：李俊剑 学号教师：刘宇安基于lcd显示器控制电路设计 摘 要 本文将主要介绍远程步进电机控制与状态显示器系统的设计及相关功能，系统由一个主机和两个从机三大部分组成，主从机主控芯片都是AT89S52单片机。系统可实现的功能是主机能够对从机发出控制命令包括步进电机转速值的设定、角度值的设定，同时将在从机采集到的步进电机实时速度在显示器上显示和实现智能控制。主机和从机之间的通信采用的是半双工串行通信方式，串行通信接口采用的是MAX485接口，通过RS-485接口标准协议实现主从机之间的通信。显示部分采用的是具有较好人机界面的TG12864LCD显示，步进电机驱动器采用NPN型的TIP122达林顿管，速度的测???通过光电传感器MOC70T2实现，系统的干扰隔离通过电隔离器TLP521-4实现。 关键字：智能控制；串行通信；LCD显示；隔离干扰Abstract This article will focus on remote stepper motor control and status display system design and related functions, the system consists of a master and two slaves three major components, both master and slave control chip AT89S52 microcontroller. System can realize the function of the host to control commands issued from the machine, including the value of the stepper motor speed setting, the setting angle value, while collected from the machine speed stepper motor display real-time display and intelligent control. Between master and slave half-duplex communication is used in serial communication, serial communication interface uses a MAX485 interface, through the RS-485 interface standard protocol for communication between master and slave. Show some use is a good man-machine interface TG12864LCD shows, stepping motor drive type with NPN TIP122 Darlington, speed measurement by optical sensors MOC70T2 achieved through the electrical system interference isolation isolator TLP521-4 implementation. Keywords: intelligent control; serial communication; LCD display; isolation interference 目 录  TOC \o 1-3 \h \z \u  HYPERLINK \l _Toc282172359 引言  PAGEREF _Toc282172359 \h 1  HYPERLINK \l _Toc282172360 1 核心部件介绍  PAGEREF _Toc282172360 \h 1  HYPERLINK \l _Toc282172361 1.1 89C51单片机简介  PAGEREF _Toc282172361 \h 1  HYPERLINK \l _Toc282172362 1.2 总线驱动芯片MAX485  PAGEREF _Toc282172362 \h 1  HYPERLINK \l _Toc282172363 1.3 光电传感器MOC70T2  PAGEREF _Toc282172363 \h 2  HYPERLINK \l _Toc2