(变压器作业指导书英文版)Method statement of electric test for transformer.docVIP

 Contents 1. General 2. Reference document 3. Commissioning preparation and work condition 4. Commissioning method and requirements 5. HSE measures and requirements 1. General 1.1 This work instruction is designed for oil-immersed transformer test of INDONESIA TANJUNG AWAR AWAR2*350MW power plant project. 1.2 150kV distribution device adopts 3/2 breaker connecting method, 2 sets of generator units are connected to 150kV bus bar via the main transformer. And 1 start/standby transformer is designed as the start and standby power all over the plant, and connected by 150kV distribution bur bar. 1 set of 150/20kV TFT is connected to 150KV bus bar according to the contract requirement. The 150KV system is made of 4 sets of complete parts. The inlet and outlet loop of transformer are all installed 3-phase voltage transformer, single phase voltage transformer is installed on the 150KV bus bar. 2. Reference document 2.1 《Electric power industry technology management regulations》 2.2 《Manufacturer specification and technical document》 2.3 《Design institute drawing and technical requirements》 2.4 《Electrical equipments installation project electrical equipment handover test standard》 3. Commissioning preparation and work condition 3.1 Keep the accessories and manufacturer technical documents are complete after positioning the transformer, and the products inspection shall comply with the technical agreement requirements. 3.2 Test shall be proceeded in the sunny day, and avoid the rainy or snowy day. 3.3 Notice the representative of manufacturer , construction unit, and supervisory company to supervise on the site before positioning the transformer. 4. Commissioning method and requirements 4.1 Transformer test procedure 4.2 Measuring insulation resistance of current transformer secondary winding : Measure the insulation resistance between secondary windings and the one