第三章掃描放样特征.pptVIP

Chapter 3第三部分 扫描特征、放样特征;Learning Objectives; 高级建模工具;图D是没有相交的截面形状和路径。 图E是扫描结果. Figure F shows the sketch of the profile and the closed path. Figure G shows the resulting sweep feature.;扫描属性对话框中的可选项有:; Show Preview; 应用扭曲选项;Swept feature created using the Follow Path option; Sweep with Guide Curves;Option available with the Guide Curves rollout are:; Sweep Feature Using the  Follow Path and 1st  Guide Curve Option; Creating a Thin Sweep Feature;图A是扫描切除对话框. The sketched profile and path are shown in Figure B. Figure C shows the resulting sweep feature created using the Cut-Sweep PropertyManager.;The Loft PropertyManager is invoked by choosing the Loft button from the Features toolbar. The Loft PropertyManager is shown in Figure A.;添加连接点的效果; 开始结束约束;Figure C shows the section for the loft feature. Figure D shows the initial preview of the loft feature. Figure E shows the preview of the loft feature with tangent at the start of the loft. Figure F shows the tangent at the start and at the end of the loft. Figure G shows the final loft feature.; Guide Curves; Guide Curves;To create a thin loft feature define the thin parameters using the Thin Feature rollout. Figure A shows a thin loft feature created using the Thin Features rollout available in the Loft PropertyManager.; 添加放样截面;Resulting section added to loft feature; Tutorial 1;Start SolidWorks and open a new part document. Invoke the sketcher environment. Draw the sketch of path of the sweep feature on the Front plane and add the required relations and dimensions to the sketch, as shown in Figure C.;Create the remaining joint features of the model using the extrude option. Using the Simple Hole PropertyManager create the holes and pattern them using the circular pattern tool. Create the counterbore hole using the Hole Wizard or using the revolve cut option. The final solid model of Tutorial 1 is shown in Figure F. The model tree of the model is shown in Figure G.; Exercise 1; Start/End Tange