arm示波器_毕业论文.doc

PAGE  arm示波器毕业论文 PAGE  arm示波器毕业论文 摘 要 本设计对基于ARM（Advanced RISC Machine）的简易示波器的设计过程进行了介绍。主要对系统的硬件设计部分和软件设计部分进行了分析。硬件设计部分首先给出了系统框图，然后对各个组成模块进行了介绍。并给出了各模块所使用的主要元器件。包括电源部分、放大部分、控制部分、键盘功能及芯片的采集和显示部分。软件设计部分编写了使能部分、AD转换、显示部分、数值计算部分。 本设计实现了小信号波形的显示，实时采样速率为1M。本设计采用彩色TFT液晶显示。本设计实现了波形峰峰值的瞬时检测和左右移动变换，实现了波形频率的测量。 关键词：ARM；示波器；AD转换  Abstract This paper describes the design of the digital oscillograph based on ARM （Advanced RISC Machine）The design of hardware and software is the paper’s main contents. At first, the hardware design part describes the floor plan of this system. Then, every module is introduced in the paper. The paper lists the main apparatus that are used in the system. Include power of the most part, and control functions, the keyboard and the collection and display chip Software design part written to be part of ad, convert, that part, the value of this issue. the application of the software is to complete the program Keil applies to software. Designed to achieve the signal waveforms display, real-time sampling is 1M. The rate is designed to achieve transient waveforms’ max-max values and move around. The waveform achieves the frequency of the survey. Key words：ARM；The oscillograph；AD conversion arm示波器毕业论文 PAGE 31 目 录 TOC \o 1-2 \h \z \u   HYPERLINK \l _Toc265248639 第1章 选题背景  PAGEREF _Toc265248639 \h 1  HYPERLINK \l _Toc265248640 1.1 课题来源  PAGEREF _Toc265248640 \h 1  HYPERLINK \l _Toc265248641 1.2 课题目的  PAGEREF _Toc265248641 \h 1  HYPERLINK \l _Toc265248642 1.3 课题意义  PAGEREF _Toc265248642 \h 1  HYPERLINK \l _Toc265248643 1.4 应用分析  PAGEREF _Toc265248643 \h 1  HYPERLINK \l _Toc265248644 1.5 本章小结  PAGEREF _Toc265248644 \h 2  HYPERLINK \l _Toc265248645 第2章 系统总体设计  PAGEREF _Toc265248645 \h 3  HYPERLINK \l _Toc265248646 2.1 总体框图  PAGEREF _Toc265248646 \h 3  HYPERLINK \l _Toc265248647 2.2 总体设计分析  PAGEREF _Toc265248647 \h 3  HYPERLINK \l _Toc265248648 2.3 硬件部分分析  PAGEREF _Toc265248648 \h 4  HYPERLI