发电机密封油系统投运(中英)选编.docVIP

CHDOC MAHAN PROJECT PAGE 7 PAGE 11 CHDOC MAHAN PROJECT 发 电 机 密 封 油 系 统 投 运 Generator sealing oil system put into operation 编号No.: 第 1 页 共 7 页（1/7） 操作开始时间： 年 月 日 时 分， 终了时间： 年 日 时 分 Operating starting time: Y M D H M； Finishing time: Y M D H MOperation Task 操作任务： 发 电 机 密 封 油 系 统 投 运 Generator sealing oil system put into operation No. 顺序Operation Items 操 作 内 容Executed 已执行Operation time 操作时间一Operation risk point, safety measures and cautions(fill in and execute base on working sequence) 操作危险点、安全措施和注意事项（按工作顺序填写与执行）1Before startup sealing oil system, keep the inside pressure around 0.05MPa in generator, in order to prevent oil go into generator. 启动密封油系统前，保持发电机内部气压0.05MPa左右，防止发电机进油。2Adjust sealing oil pressure differential, in order to prevent oil go into generator. 调整好密封油差压，防止发电机进油。3Pay attention to air side and H2 side sealing oil tank oil level, in order to prevent oil go into generator. (H2 side anti-foam tank severe alarming, oil is tend to go into generator) 注意空、氢侧密封油箱油位，防止发电机进油。（氢侧消泡箱高报警，发电机易进油）二Operation Item(fill in and execute base on working sequence)操作项目（按操作顺序填写与执行）1Receive shift in charge engineers order, ___Unit generator sealing oil system put into operation. 得值长令， 号发电机密封油投运。2Check ___ Unit generator sealing oil system and related auxiliary equipment maintenance work finished, work permit ended. 检查 号机发电机密封油系统和相关辅助设备的检修工作结束、工作票终结。3After confirm oil quality is qualified, __ Unit generator sealing oil tank oil level rise to normal high level. 检查油质合格后， 号机发电机密封油油箱油位加至正常高油位。操作人 (Operator) ______________ 监护人(Supervisor) _____________ 值班负责人(Responsible):__________________ 值长 (Shift-chief):_______________ 发 电 机 密 封 油 系 统 投 运 Generator sealing oil system put into operation 编号No.: 第 2 页 共 7 页（2