chap1交换机基本配置及使用v2.ppt

第一章 路由器/交换机基础知识 和交换机的基本配置 ;1.1.2 初始化配置对话模式 提示语句如下: Would you like to enter the initial configuration dialog? [yes/no]: 如果选择n，则进入IOS的命令行界面CLI（Command Line Interface），以命令行方式对路由器（或交换机）进行配置 如果选择y进入对话模式，那么系统会通过一系列的问题指导用户对路由器（或交换机）进行配置 --- System Configuration Dialog --- Would you like to enter the initial configuration dialog? [yes/no]: y At any point you may enter a question mark ? for help. Use ctrl-c to abort configuration dialog at any prompt. Default settings are in square brackets []. Basic management setup configures only enough connectivity; for management of the system, extended setup will ask you to configure each interface on the system Would you like to enter basic management setup? [yes/no]: yes Configuring global parameters: Enter host name [Switch]: myswitch The enable secret is a password used to protect access to privileged EXEC and configuration modes. This password, after entered, becomes encrypted in the configuration. Enter enable secret: mysecret The enable password is used when you do not specify an enable secret password, with some older software versions, and some boot images. ; Enter enable password: CR #按enter键 % No defaulting allowed Enter enable password: cisco The virtual terminal password is used to protect access to the router over a network interface. Enter virtual terminal password: myvty Configure SNMP Network Management? [no]: CR #按enter键 Current interface summary Any interface listed with OK? value NO does not have a valid configuration Interface IP-Address OK? Method Status Protocol; Vlan1 unassigned NO unset up up FastEthernet0/1 unassigned YES unset down down FastEthernet0/2 unassigned YES unset down down FastEthernet0/3 una