年产63万吨热轧线材车间毕业论文40论文41说明书.docVIP

PAGE  PAGE   PAGE \* MERGEFORMAT 2 (此文档为word格式，下载后您可任意编辑修改！) 毕业设计论文说明书 年产63万吨热轧线材车间设计 摘　　要 根据毕业设计的要求，设计年产63万吨的热轧高速线材生产车间，采用单线轧制方式。产品规格为Φ5.5~16mm，单卷盘重约2吨。本设计产品包括碳素结构钢和优质碳素钢。 本车间设计的内容主要有：产品大纲和金属平衡表的制定；设计工艺方案和工艺流程；工作制度的确定及轧机生产能力分析；主要设备的选择；辅助设备的选择及计算；车间平面布置及起重运输；车间技术经济指标；环境保护；孔型设计；轧机力能参数计算及电机设备校核等。 本设计原料采用连铸坯，以减少金属的损失，而且连铸坯的组织结构较好，这也提高了产品的质量；还可以减少轧制间隙时间，提高生产率。 加热炉为步进梁式加热炉，进出料方式采用侧进侧出，以保证炉子的严密性，加热能力为120t design, a new single line of this design include the carbon structural steel and steel. The main contents of the design are mainly as follows, formulation of products scheme and metal balance, design of technological plan and process, the determination of work routine and production capacity analysis of rolling mill, choice of the main equipment, choice and calculation of the auxiliary equipment, the grooves design, the layout of workshop and etc. The continuous casting billet is used as raw materials in this design to reduce the metal loss. The better microstructure of the billets can also improve the quality of the product and reduce the rolling gap time to increase productivity. The reheating furnace is a walking beam type furnace which is side entry and side exit to ensure the tightness of the furnace. The this workshop. No twist rolling is realized across the rolling line. The finishing ensure speed is 100 m s, maximum rolling speed of 120m s. The controlled cooling technology is used after rolling through the cooling water box and a Stelmor cooling conveyor system to improve product microstructure. Stelmor transportation system by the delayed cooling type cooling transport devices, which applies to various carbon steels and short, the advanced technology and equipment, the design of the product is an important guarantee of workshop designing. Key Words: workshop design high-speed wire rod and wire mill controlled rolling  ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ 装 ┊ ┊ ┊ ┊ ┊ 订 ┊ ┊ ┊ ┊ ┊ 线 ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ 安徽工业大学工商学院 毕业设计（论文）说明