毕业设计（论文）-基于PLC的煤矿全皮带运输集控系统的设计（全套图纸）.doc

 PAGE \* MERGEFORMAT II  PAGE \* MERGEFORMAT I 摘要 皮带输送机作为一种连续输送物料的搬运机械，主要用来输送块状、粒状和散状的物料，被广泛应用于现代工业生产。但是在连续运行中，往往会出现过热、跑偏、撕裂、堆煤、火灾、打滑等故障，给工业生产带来不便和损失，甚至会造成人员伤亡。针对煤矿皮带运输系统运行距离长、站点多、运行参数多等特点，可以使多条皮带实现互联互通与资源共享，协调综合应用，最大程度的避免人力及物力资源的浪费，达到减人提效的目的。 本设计是以泗河煤矿为背景，结合工程实际，为泗河煤矿西巷井下全部四条皮带而设计煤矿皮带运输集控系统。该系统未设计之前各条皮带功能相对独立，很难做到协调工作，容易造成安全事故。该系统以PLC为核心，代替了传统的继电器控制系统，通过传感器监控皮带的各种信息，把传感器信号传入PLC，经过一系列的处理、判断，控制皮带的启停，使得皮带能够一直运行在合理状态。从而实现了井下皮带的集中控制、单独控制、传感器实时数据传输与及时报警，进一步提高了井下生产的可靠性和安全性。 关键字： 皮带运输机；PLC；集控系统；传感器 全套图纸，加153893706  PAGE \* MERGEFORMAT II  PAGE \* MERGEFORMAT I Abstract The belt conveyer is a kind of conveying machine for continuous conveying material, which is mainly used for conveying massive, granular and bulk material, and is widely used in modern industrial production.. But in continuous operation, often appear overheating, deviation, tearing, heap coal, fire, such as slipping fault. To the industrial production brings inconvenience and loss, and even cause casualties. According to the characteristics of coal mine belt transport system for long distance, multi site, operation parameters and can be multiple belt to achieve interoperability and sharing of resources, coordination of comprehensive application, the maximum to avoid the waste of manpower and the physical resource resources and to increase the efficiency. This design is in Sihe Coal Mine as the background, combined with the practical engineering, Si River Coal Xi Xiang underground all four belt designed coal mine belt transport control system. The system is not designed before each belt function is relatively independent, it is difficult to coordinate work, easy to cause accidents. The system with PLC as the core, to replace the traditional relay control system, through various kinds of information of sensors to monitor belt, the sensor signal to be transmitted to the PLC, after a series of processing, judging, belt control the start and stop, the belt has been able to run in a reasonab